G-8VXWWTRHPN Search Result - VWWatercooled Australia

Announcement

Collapse
No announcement yet.

Search Result

Collapse
26 results in 0.0111 seconds.
Keywords
Members
Tags
loom x
  •  

  • Transporter Injector/Engine Loom

    I'm pleased to find this forum with lots of other Aussies sharing the VW passion!

    Ive got a 09 T5 2.5 BPC and having troubles with the plug on the injector loom on the car side and can't wait to get her back on the road.
    See more | Go to post

  • Headlight wiring insulation disintegrating - new loom?

    My headlight wiring insulation is failing. It 's affecting the wiring in the actual headlight itself. Apparently this is a thing. WTF?

    Noticed it after a bulb blew. Off course it comes just after I spent a few hours polishing the discolored lenses.....and ordering new bulbs...
    ...
    See more | Go to post

  • gfunk_nz
    started a topic Mk2 factory amp loom routing

    Mk2 factory amp loom routing

    I am trying to get access the the amp loom a few inches back from the connector to splice in a line out converter on the rear sub channels. I’ve lifted sections of carpet after removing the sill trim, but cannot find where it runs exactly. Can anyone shed any light before I have to remove the passenger...
    See more | Go to post

  • bobmac
    started a topic bobmac

    bobmac

    Have a 2008 Golf Mark V TDI owned since 2013.
    It has been a great car except for the electronic door and boot (hatchback) locking modules. Have had to replace all door modules except driver's. The boot problem was due to broken wires in the loom caused by the flexing during opening and closing....
    See more | Go to post

  • vorleys1982
    started a topic MAF Sensors, Wires and broken connectors

    MAF Sensors, Wires and broken connectors

    Hi All,

    I did search for an existing thread so apologies if I have doubled up, but I didn't see any posts similar to this.

    I have a 1.4 tsi twin charge (CAVD) Golf 2010. For years I've had issues with power delivery, fuel economy and choked up plugs. I had several other...
    See more | Go to post

  • Retrofit 2.8 BDE loom into 3.6 BWS loom = ?

    Here is a project that has been a long time coming and I hope it is a fruitful venture. I'm sure there will be many perils and pitfalls along the way but, if you know me, i find that that is the part that once overcome, is the most rewarding.

    Here we go...

    I've spent hours...
    See more | Go to post

  • Schalke04
    started a topic NSW Golf mk2 Gti 1.8t conversion parts

    Golf mk2 Gti 1.8t conversion parts

    I’m currently upgrading my 1.8t mk2 with a big turbo and newer ecu so have a lot of old conversion parts for sale.


    Mk2 ce2 to 1.8t agu conversion loom adapter
    Agu wiring loom
    Mk3 engine mount kit with Passat vr6 front engine carrier and all 16v abf engine mounts...
    See more | Go to post

  • Differences in wiring loom plugs t5 to t5.1

    G'Day,

    I need to get some loom side plugs (damage from previous owner) for my brakes and the bonnet release. Seems a lot more common (and cheaper) to find a t5 being wrecked rather than a t5.1. Can anyone confirm if these plugs are the same across all t5's, or will I need to search more...
    See more | Go to post

  • Mk3 caddy maxi. New bloke.

    Hi all. I’ve got a 2008 caddy maxi with 1.6i and 5speed manaual. This motor is locked up. I also have a mk5 Jetta with 2.0 FSI and 6speed auto to fit to caddy. Mechanically the swap looks doable but the Jetta loom will need to be used partly at least I think. Does it splice in to the caddy loom ok?...
    See more | Go to post

  • Aftermarket Stereo Troubleshooting Assistance

    Hello all,

    I've recently upgraded the stereo in my 2007 Golf (with the half cluster dash) from the RCD310 unit to an aftermarket unit I purchased from an online store.

    Everything from removal of the old unit to the new WinCE based unit has gone well, even the installation...
    See more | Go to post

  • Hello, I'm a Newbie with an R36

    Hello everyone , just doing my introduction. I haven't logged in for a while and noticed the welcome message directing me to post this!

    I have a MY2010 Biscay Blue R36 wagon that I think is the best car I have ever owned, and will keep it for the foreseeable future.

    Mods...
    See more | Go to post
    Last edited by Bluey2010; 20-03-2019, 11:14 AM. Reason: more info

  • Getting the rear view camera to work with trailer assist

    So With trailer assist and no rear view camera the camera is actually there it just has the video feed loom missing , went to vw and asked if they do just a video feed loom, they don't do any looms that's not supplied with the car, so got the loom out of my camera kit (the loom is for sale on UK eBay...
    See more | Go to post

  • jets
    started a topic Mk5 TDI Rodent Damage

    Mk5 TDI Rodent Damage

    Anyone else had this problem? Started car one night while out & noticed some of the dash warning lights didn't come on.
    Made it home OK but lifted bonnet in my garage & shone a torch around & confronted with this.

    Next day I pulled the front of the car to pieces to extract...
    See more | Go to post
    Last edited by jets; 24-06-2017, 08:57 PM.

  • mk2DREW
    started a topic NSW Mk2 abf conversion loom

    Mk2 abf conversion loom

    Hey all, i'm starting to look for/ accumulate parts for an ABF swap later in the year. Any info on acquiring a loom/ ECU would be massively helpful! To suit Ce2 fusebox!

    cheers
    See more | Go to post

  • DAM GTi
    started a topic SA Me7.5 aum audi tt ecu loom acc.

    Me7.5 aum audi tt ecu loom acc.

    full loom
    dbw peddle
    all sensors
    cluster
    plus more

    wanting to convert the simple ecu you have to tunibility you want-this is it!

    $500

    post anywhere in australia

    S&H-$50


    pm/ring

    Dan-0412057026...
    See more | Go to post
Working...
X