If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
Celica offsets are much higher like the WRX's. May need spacing.
The tab in the wheel arch is simple, remove screw, push plastic over the tab and bend the tab up a little. I would be more worried about the inside clearance on full lock, but if you hack at the moulding or change it, you may have the sweetest stance around...
The GT-Four offset is lower, pretty sure it's 38 or 35 which makes me think they will fit the polo relatively ok
Today I found a squeak that's been annoying me for weeks - a couple of the clips on the plastic tray under the motor had come off and it was wriggling around. All quiet now
I'll get the camera out later tonight when i get home.
Fixed my tyre - Oh sweet relief of not having to buy another one
PS those wheels look effing HOT on the Celica, leave em on there, get some newbies for your Polo!
Heh, thanks mate
I only thought about doing it as the Celica will be getting sold soon, hasn't been driven for over a year
I would buy some new wheels but I am broke!
Hmm although...once the Celica sells, maybe some of the money can be 'misdirected' to a set of new wheels
Haha, trust me, it's not that much. I really like the look of it. It's a bad pic, but better ones are on the way.
Now I can Clean the brakes without taking the wheels off the car!!
"If can't get behind your troops, feel free to stand in front of them..."
Wheel size is 18x8 ET35, and tyre size is 225/35 18. No spacers, and they fill out the guards completely... I have about 8mm clearance from both the strut on the front, and the inner guard on the rear, and then I have about 1mm of poke on the front, and they are just tucked in on the rear.
"If can't get behind your troops, feel free to stand in front of them..."
Comment