APR ECU Upgrade MK6 Golf - Customer perspective

[POLARBEAR666]

If I get a chance to do another run somewhere/time in the future I'll try getting both tunes run....

But next will possibly be some sort of Down Pipe and air intake....

I have seen dyno runs of stock cars putting out that same ~120kw@wheels. Also seen some cars do runs of 110kw only, so if your car was lowish at 110kw range then 8kw peak gain is ok.

What really concerns me is that the torque figure is WAYYYYYY lower than what APR claims at engine. They claim 300nm+ and the derived torque on that dyno was low 200's! a stock result.
There is no way that the dyno was almost 100nm inaccurate so the torque reading is VERY low for what APR claim.

In contrast your on the road logs seem to show good real world driving gains. This could simply be due to more boost causing a change in gearchange selection by the car, less changes or changes to lower gears could account for your faster times. We really need some GTI results from that day.. or ask the dyno operator to overlay the most recent GTI he has had on that same dyno onto your chart.

[Maverick]

I have seen dyno runs of stock cars putting out that same ~120kw@wheels. Also seen some cars do runs of 110kw only, so if your car was lowish at 110kw range then 8kw peak gain is ok.

What really concerns me is that for some reason you seem to believe a dyno is a scientific device that has no room for error, perhaps consider the hundreds of variables that can and do affect the results.

What really concerns me is that the torque figure is WAYYYYYY lower than what APR claims at engine. They claim 300nm+ and the derived torque on that dyno was low 200's! a stock result.
There is no way that the dyno was almost 100nm inaccurate so the torque reading is VERY low for what APR claim.

There are many reasons why that dyno could have been that inaccurate.

In contrast your on the road logs seem to show good real world driving gains. This could simply be due to more boost causing a change in gearchange selection by the car, less changes or changes to lower gears could account for your faster times. We really need some GTI results from that day.. or ask the dyno operator to overlay the most recent GTI he has had on that same dyno onto your chart.

Doing any of any of those would be absolutely pointless. A dyno is a tuning device and not a power measurement device. They're really only useful for doing a before and after measurement and the manufacturers of the dynos say this as well.

Mainline Dyno

Dynapack say "Remember dynos are not an accurate power output device. A dyno is a tuning tool which allows a tuner to apply variable amounts of load on an engine testing its performance in all load and throttle positions. The only conclusive evidence which can be drawn from any dyno is a before and after result. A car started off with this much power, and now has this much."

http://sdsefi.com/techdyno.htm "Chassis dynos are essentially tuning aids, not true hp measurement devices. Use them to dial in your EMS mapping, not to brag to your friend's that you made XXX hp. When he blows you away at the stoplight, you'll just look, just, well, uninformed."

and so forth.....

[logger]

In contrast your on the road logs seem to show good real world driving gains. This could simply be due to more boost causing a change in gearchange selection by the car, less changes or changes to lower gears could account for your faster times.

Presumably there will be more boost with the tune and this could explain some of the performance gain. Probably more to it though. If you review the graphs above again, you will see that change points are noted and they do not differ until Stock takes 6th gear. Prior to this, the change points are identical with marked different acceleration. So my take on it is - increased engine torque is producing the improved acceleration. Which is what you would expect.

But I too would be interested in Guys comments re the Mainline Dyno log showing so much less torque that the APR figure for the tune. Apart from all the reasons Maverick mentions, explaining why chassis dynos are an inaccurate way to measure absolute engine torque. Could it just be that the APR figure is what they have calculated the tuned Engine torque is at the flywheel. They show this because it can be compared to VWs claimed 118kw & 240nM for the stock tune.
So for example in real simple terms they could Chassis dyno 1) stage 1 tune and 2) No tune, note the difference as xKW and yNM and apply these increments to known VW stock 118KW and 240NM engine dyno figures to the arrive at their claimed figures. Which seems reasonable to me..

[GTom]

But I too would be interested in Guys comments re the Mainline Dyno log showing so much less torque that the APR figure for the tune. Apart from all the reasons Maverick mentions, explaining why chassis dynos are an inaccurate way to measure absolute engine torque. Could it just be that the APR figure is what they have calculated the tuned Engine torque is at the flywheel. They show this because it can be compared to VWs claimed 118kw & 240nM for the stock tune.
So for example in real simple terms they could Chassis dyno log 1) stage 1 tune and 2) No tune, note the difference as xKW and yNM and apply these figures to known VW stock 118KW and 240NM to the arrive at their claimed figures. Which seems reasonable to me..

VWs figure is also a

which is also from an engine dyno and coluld not be produced on a chassis dyno.

whereas Dyno log the Chassis my guess it is due to how the two are measured.

http://www.vwwatercooled.org.au/newforum/upload/showpost.php?p=412853&postcount=129

[logger]

Thanks - that explains the gains APR measured between stock & tune - of which I have no doubt. It does not explain the apparent low figures you dyno'd compared to APRs peak figures of 151kw & 317nm. Just wanting Guy to confirm that apparent disparity is merely due to your figure being at the wheels and the APR one being what you would expect on an Engine Dyno if you could test it..

[Guy_H]

The Mainline nor the Dyno Dynamics can give an accurate figure on torque, (discussed in about 10,000 dyno day threads).

If you want closer true torque numbers you can use an engine dyno - or use a Maha or Bosch dyno (3rd generation type).

The torque figures as already quoted are derived from tractive effort - so comparing the wheel numbers to a flywheel figure is completely pointless!

[logger]

..
Best time with Stock_________7.6 sec._______Speed @ 400m 118kph
Best time with APR Stage 1____6.9 sec._______Speed @ 400m 132kph

Max time gain 0.7 sec with the tune,....

APR Stage 1
Metric units
0 to 100 km/h: 6.9 +- 0.23s
400m: 15.3 +- 0.23s, @132 km/h
90-120 km/h: 3.5 +- 0.24s

above from Post #30

Interesting to see now the GTI is here, that these times with the APR Stage 1 tune on the twincharger aren't too shabby at all when comperd to what Guy has come up with the stock GTI (7.2 sec). Broadly they show the 0-100 time of the tuned TSI118 to be the same as the Stock GTI. Of course I only measured using VCDS which is not at accurate as Guys kit. It makes the tuned TSI118 at 32.5k pretty good bang for your buck.

[guliver_twist]

from what logger posted of APR stage 1 doing a 0-100 of 6.9 seconds and Guy H. post on the Stock and Stage 1 gti looks like the 1.4tsi with APR tune is slightly quicker or about equal to a stock GTI...

Originally Posted by Guy_H View Post
OK, latest updates are on:

Stage 1 installed, dyno complete, stage 2 installed (Carbonio Airbox & downpipe + High flow cat) - Dyno complete.

Acceleration runs : (0-100)

Stock = 7.2
Stage 1 = 6.6
Stage 2 = 6.2 seconds.

Found it extremely difficult to launch the car (Manual trans) - the balance between wheel slip, bogging down & short shifting was difficult.

Times were run on Racelogic Performance box, yesterdays heat (Stage 1 & stock) was 32.5 degree's - todays heat (stage 2) was 35.5 degrees.

[Guy_H]

I would vouch for that - the power delivery of the twincharger is really deceptive (Its faster than it feels)

[GTom]

Now we just need stage 2 + for the 1.4

[MaccaTSI]

Looking at these figures, even in stock form there is not too much of a difference between the 118TSI and the GTI. I understand there may be a bit of variance due to the fact that you have both measured in different ways, (and one car is DSG, the other manual) but still, it shows how good of a bargain the 118TSI is.

Guy, you said that it was hard to get the power down with the manual gearbox, do you think a DSG car would show more of a difference/better figures?

[Ollie]

Does the APR Upgrade void VW manufacture warranty?

[elisiX]

The Stage II sounds reasonable in the GTI but you think its going to be much better (takeoff) if you have the DSG Guy?

This has me really interested for my GTI which arrives in March/April.

[POLARBEAR666]

Now we just need stage 2 + for the 1.4

Guy, any idea on when stage 2 will be released?

Your results of 6.2 is awesome and makes the "whole hog" straight to stage 2 very tempting. Might have to take the ancient lucky band off my wallet and blow off the dust.

[GTom]

Guy, any idea on when stage 2 will be released?

Your results of 6.2 is awesome and makes the "whole hog" straight to stage 2 very tempting. Might have to take the ancient lucky band off my wallet and blow off the dust.

VW Racing UK have some bits for the 1.4, lightened and modified turbine wheel etc etc.

http://www.millteksport.com/vw.racing_vw.golf.gt.tsi.cfm