Hi Guys,
Ive just lowered my transporter about 150mm all round also fitted some H&R Sway bars. Too finish it off with some 20" alloys .
The problem is i want to go lower..
Since lowering it ive got very bad drive shaft judder which is relatively common when lowering alot.
Its only when i turn left apparently its the drive shaft angle is way to tight.
So been from the UK ive been on a few forums over there and spoke to a few guys that have come acrosss this i need to do a engine raise which invoives moving up the engine mounts and cutting 25mm out of the subframe.
Does anyone know anyone that can help out or point me in the right direction?
Has anyone already done this its a pretty common mod to do in the UK.
Im on the Gold Coast
Comment