If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
Have you worked out (I admit I can't remember reading it) what you estimate you will produce from this set up at the wheels?
Kind of like telling everyone how long my cock is, but from what i can work out off other similar setups, it should make 200hp at the flywheel. But who knows. And i'm not really fussed about power figures.
So here it is. I pulled the old drive shafts out. Then I used 16mm threaded HT rod. 120mm long.. But 100mm would have been adequate, FYI. Big, thick washers both sides. Locked them up, done. Now you can push it around without drive shafts and not hurt the wheel bearings..
Comment