G-8VXWWTRHPN Search Result - VWWatercooled Australia

Announcement

Collapse
No announcement yet.

Search Result

Collapse
48 results in 0.0134 seconds.
Keywords
Members
Tags
idle x
  •  

  • BruceM
    started a topic WA Golf 1.4 compression issues

    Golf 1.4 compression issues

    Hi All,
    I am a new member to this forum and am looking for assistance/advice/suggestions with respect to my wife’s 2012 118TSI GOLF which has low compression on 2 cylinders (causing rough idle and occasional loss of power). Have you had experience getting VW Australia to cover the rebuild cost?...
    See more | Go to post

  • Veselin_
    started a topic how much vacuum

    how much vacuum

    Hello,

    how much vacuum there should be at idle?

    engine:1.4 tsi 110 kw

    thanks
    See more | Go to post

  • Passat my07
    started a topic Rough idle when cold

    Rough idle when cold

    Hi everyone,
    I’m trying to fix a rough idle when cold on my brothers 1.4 twin charger gt.
    I scanned it with a launch scanner and nothing came up. When you take the oil cap off the idle is the same making me think it’s an engine breather system fault. It doesn’t seem to have a normal...
    See more | Go to post

  • T5.1 CFCA Stall, Then Very Rough Idle

    Hi guys,

    Currently researching my problem through these forums and such.

    Long story short, about 20mins ago I started my Van, put it into reverse (DSG), while reversing it suddenly stalled. Then I tried starting it and the motor/starter? was whining badly. After a few goes,...
    See more | Go to post

  • Terryb
    started a topic T4 map sensor help

    T4 map sensor help

    Looking for some help as I have a 1996 T4 - 2 litre has an issue with the engine 'hunting' at idle, flat spots at low revs and stalling on idle. Leads, rotor button, distributor cap and many hoses have been replaced but the problem remains. I’ve been told the map sensor is failing and (probably)...
    See more | Go to post
    Last edited by Terryb; 02-07-2019, 04:05 PM. Reason: spelling errors

  • joe77
    started a topic B5 passat issue please help

    B5 passat issue please help

    Hello everyone,

    2002 v6 passat. Car would start idle at 500rpms for a second and die. This happened for about 10 min of intermittent trying. After that 10 min the car would then idle but unless I rolled on the gas very lightly the car would die. If I roll on the gas lightly and let it rev...
    See more | Go to post
    Last edited by joe77; 10-01-2020, 04:46 AM.

  • Bozfromoz
    started a topic Idle problem

    Idle problem

    Hey guys I have another little problem to fix on my golf 2.0 se. The car drives well and idles well when it’s in park however when it’s in drive on idle or reversing it not smooth almost like a misfire but no error codes and this doesn’t happen all the time. Any help appreciated. I will change...
    See more | Go to post

  • avl
    started a topic Lumpy idle on an '08 GTI

    Lumpy idle on an '08 GTI

    Hi everyone,

    Looking for some advice regarding a lumpy idle on a 2008 spec GTI.

    I bought the car with 106,000 kays on it, and the idle was dead smooth. Within a month or so it started to get a little lumpy every now and then.

    It's become progressively worse ever...
    See more | Go to post

  • saabman
    started a topic 2.0 FSI Poor idle when cold

    2.0 FSI Poor idle when cold

    After my daughters Golf left her stranded for a while Ive swapped my trusty SAAB for her dubious Golf

    Ive got most things sorted out from door locks to faulty light switches, broken wires etc. But I am stumped on this one.

    When starting from cold.

    fires almost...
    See more | Go to post
    Last edited by saabman; 25-02-2019, 10:03 PM.

  • usernametbh
    started a topic MK6 1.4 TSI clicking/tapping noise

    MK6 1.4 TSI clicking/tapping noise

    Hey Team,

    I picked up a 1.4 tsi with 35,000km from a used car dealership about a month ago, over the last week I've been noticing that the initial idle after a cold start is pretty rough and shaking the car, then when it settles into the lower rpm idle there's the tapping/clicking shown...
    See more | Go to post

  • jdclayton
    started a topic 118tsi rough idle

    118tsi rough idle

    Hi guys,

    Been moving around a bit and a little behind on servicing (past time but not kms) have had a little issue with rough idle, hoping its not a piston issue. Just wondering from those who have had engine issues what the tell tale signs were? Mine seems to be fine if I just give it...
    See more | Go to post

  • Mysterious uneven idle

    My 2007 T5 4 motion is an ex ambulance with the slightly raised Bilstein suspension. It has only just clicked over 150k (i've owned it since 24k). It has recently developed an uneven idle. There does not appear to be any loss of power or increase in fuel use. The uneven running seems to disappear above...
    See more | Go to post

  • Clutch in idle while moving low

    Hey,
    I had a vac leak that I'm pretty sure was causing hunting idle, I'm pretty sure I got it, no more hunting. But If I put the clutch in while moving it'll "idle" at ~600rpm and then when I come to a stop duck back up to the usual ~820rpm.

    Is this normal for a 1.8t??...
    See more | Go to post
    Last edited by jmcc; 03-05-2018, 08:45 PM. Reason: Issue update

  • EPC Light Check Engine Light, crummy idle and no acceleration

    Hey Guys!

    I have a 2011 1.2lt Mk6 golf and it recently stopped working.

    Whilst i was driving normally the EPC light came on, so did the check engine light, the steering wheel light? (maybe power steering) as well as the traction control light. I completely lost acceleration...
    See more | Go to post

  • S_osborne
    started a topic 1996 1.8L high and/or low idle

    1996 1.8L high and/or low idle

    So i have a 1996 1.8 mk3 golf CL and just recently my idle has either been high at 1200-1600 rpm or really low at 500 rpm and about to stall. This only occurs when it's warm and the engine has had a little bit of load applied. I've checked and replaced old vacuum lines and that word for about 30 minutes...
    See more | Go to post
Working...
X