**SOLD**

Selling a set of USP Motorsports "Spulen" wheel spacers with extended wheel bolts from Mode Auto Concepts.

Spulen Flush Kit For Audi Q5/SQ5 - WSKT-Q5F - 75006928 - USP Motorsport

MODE PlusTrack Extended Lug Bolt w. Loose Collar 14x1.5 Black...

Hi
Does anyone know when VW started to use the none ribbed front driveshaft bolts from the ribbed ones ?.

cheers
Scot...

Hi All - appreciate any help on this one

A wire has broken off to one of the motors under my drivers seat (the one that moves the seat forwards or backwards). I've unplugged the cable loom from the cable connector in the motor and, looking closer, it seems the wire has snapped off right...

Broke the folding key part off the fob the other day and had to resort to the manual spare key {could not find the second fob DOH ! } So been using the spare key for the last few days and then this morning the actual barrel just decided it would not turn , no matter what I did jiggling the key turning...

I have a Mk 6 GTI with 150K on the clock. I maintain it pretty well and am aware of the usual things. You know, a coil on plug sh*ts itself so I replace all four, because the drive home was so heinous I never want to experience that again. All has been good and I just serviced the thing (I do it myself)....

I’m replacing the front pads and rotors on our 2018 Arteon and would like to know the torque specs for the 21mm calliper carrier bolts and the 13mm guide pin bolts?

Any advice or tips would be appreciated as well

apologies in advance if already covered somewhere, I tried searching and found a gazillion hits but none seem to actually have what I was after..

anyone know the lug bolt sizing for the new Tiguan? I assume they are the same across trim levels, but if not specifically the mk2 R-Lines with...

Hi,
Just wondering if anyone has a aftermarket 3 seat bench in the back of their transporter and could take some photos of the mounting bolts for me?
move got a ‘Wilshire’ seat in mine, missing bolts to refit. Looks like a tech safe type seat, forward flipping type.

c...

M21 Trendline


Using either the key or a regular flat tip screwdriver, turn the locking screw 90<sup>0


and pop the tab out






Locate the securing bolts.


Hex key required to remove the bolts pre-installed</sup>...

Does anyone now the torque value for the body mount bolts? I put a small body lift on my rok and I feel like it is not tight enough but don't want to just rattle the bolts up in fear of ruining the factory body mounts themselves.

I must have misread a bunch of advice and sourced an RT10 Ribe 1/2" bit for the head bolts on my T4, however on closer inspection they appear to be a spline.

Are these triple squares M12s?

Asking before I spend more of my hard earned on tools I will never use again....

I installed a new transmission mount and snapped two bolts (#3 in the diagram).

The Bentley repair manual mentions that the bolt is to be torqued to 100nm. I didn't even get to 70nm before it snapping. It was seated correctly and I had hand tightened it prior to using a torque wrench. ...

Hi I have taken the towbar off my mark seven without realising that the bolts are specifically torqued . I have a Hayman Reese towbar. Wondering if anyone knows what setting I should be using to retension the bolts. By the way the towbar is on the older type with bolt mated to two flat metal bars

I've searched everywhere & cant find one.
I have the front off vehicle & im down to removing the oil filter housing which hosts the oil cooler. I cant see a way to take the oil cooler off without the filter as there are bolts inside under a manifold.
However, even the ol filter...

Hi all, just wondered if anyone has had or heard of this issue?

My 2018 Transporter just went into my local independent for routine service - 30000k's. It's a joy to drive & planning on keeping long term, 10+ years. Mechanic spotted an oil leak around the bottom of the bell-housing...