What have you done to your mk4 (golf/bora) today?

[RolfGolf]

Here's the latest shoes on my Golf Wheels from an Audi S4. What do you think?

It's got to be a thumbs up from me as I'm rocking the same wheels - albeit in silver

(I've got some sneaky ABT 18's in the wings though ...)

[RolfGolf]

Hey Dylan, I gather you can order the black section separately if you trash it?

[dylan8]

Not sure, didn't look at that. But being steel will be easy to weld the cracks or weld a plate to

[lemontree]

It's got to be a thumbs up from me as I'm rocking the same wheels - albeit in silver

(I've got some sneaky ABT 18's in the wings though ...)

Nice! Got a picture of your car? I had second thoughts of the powdercoated rims (was bought used). But I'm starting to like it. Thinking of roof racks next!

[Lito]

Found out the hard way that I had a blocked sunroof drain

[dylan8]

oh dear! lots of water. just the passenger front?

[RubAVeeDubDub]

cos race car and good handling


my sump didnt have a mark on it until last oil change.
engine mounts have worn and dogbone looks twisted, so engine is hanging much lower.
just ordered this

not sure if it will sit any higher, but atleast it will stop the leak and any futura damage to the lower section can be repaired easier

So wish there was something like this for my V6 AUE.
I'm on my third sump and it needs to be replaced. And I'm still like 110mm off the ground. :/

[lemontree]

Installed my new thule racks

[dcups(dailymk4)]

....my North American front bumper with mould and smoked bumper blinkers arrived to match up with my 20th Anniversary valance. Note that 25th Anniversary valances only match up with Euro fronts like here in Oz. But i wanted to be different....u.s. ones are also an inch deeper

[dylan8]

Different in the curve or clip locations

[dcups(dailymk4)]

Different in the curve or clip locations

yes this as well . Apparently 20th's fit Bora's =) same depth, different clips i think.
Great thing about genuine VW bumpers, valances is that they're so flexible that when my 20th valance was shipped
both sides of it were folded in behind the valance to save length for shipping prices. Returned to shape after a few days of unpackaging

Got a Skene and Calvert front license plate bracket for it also since there isnt a place for it to mount.

[dcups(dailymk4)]

here's my North American bumper with my U.S 20th Anniversary valance 'test' fitted and fits perfect.

Just need a heat gun to undo some slight bends on the plastics due from travel =) Going in the workshop soon to fill that ugly bumper notch.

[BLN355]

Should look real nice once painted up.

[RM86]

Where you source that bumper dude? I'm looking for something similar or a full Annie kit and debadge it before i get my repaint at the end of next month

[dylan8]

going to hook the side markers up?
should look mint painted