Above Forum Ad

Collapse

Announcement

Collapse
No announcement yet.

VDUBIN (VR6) aka Chop N Change

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • vdubin
    replied
    Originally posted by thestu View Post
    You should have some room under the car on the right hand side...OR...make a tank to fit between the rear bar and the chassis...there is a bit of room there

    Stu
    You sure know your stuff man,I will check thoes spots once I have it Jacked up.

    I just really want to fix this issue with my car first, Apprently its the MASS Air Flow Sensor thats making my car run like a bitch,hopefully borrowing one of a mate to see if thats the case.


    Originally posted by sortofbigbj View Post
    Make ther car air tight and just tell passengers to deal with a mild pushing sensation all around them?
    LMAO...

    Leave a comment:


  • dark
    replied
    Originally posted by thestu View Post
    You should have some room under the car on the right hand side...OR...make a tank to fit between the rear bar and the chassis...there is a bit of room there

    Stu
    yikes!! Is it dangerous to have the air outside the car?? In a crumple zone?

    Leave a comment:


  • Ben J
    replied
    Make ther car air tight and just tell passengers to deal with a mild pushing sensation all around them?

    Leave a comment:


  • thestu
    replied
    You should have some room under the car on the right hand side...OR...make a tank to fit between the rear bar and the chassis...there is a bit of room there

    Stu

    Leave a comment:


  • vdubin
    replied
    Originally posted by Jarred View Post
    wheel well isn't a pressure vessel. don't do it.
    Trust me I was never going too lol.way to risky

    Originally posted by Stan View Post
    sensational thread mate, you've done some very nice looking work, well done!
    Thanks alot stan.

    Originally posted by dark View Post
    Nice looking setup there!
    Cheers Dark,I really wish I had more room for another Air Tank but I love music & bass just much.

    Originally posted by thestu View Post
    That's with 2 conpressors. Fine Jarred lol get a donut tank?
    Oh true..Well I can't go back now I want a sub,Lets hope I dont regret this later on..lol

    I did find Two tiny Gass tanks that might look sweet as Air tanks,Im going to place them around the boot tommorro & see if it will work.

    Leave a comment:


  • thestu
    replied
    That's with 2 conpressors. Fine Jarred lol get a donut tank?

    Sent from my GT-I9000 using Tapatalk

    Leave a comment:


  • Jarred
    replied
    wheel well isn't a pressure vessel. don't do it.

    Leave a comment:


  • dark
    replied
    Nice looking setup there!

    Leave a comment:


  • Stan
    replied
    sensational thread mate, you've done some very nice looking work, well done!

    Leave a comment:


  • vdubin
    replied
    Originally posted by rayray086 View Post
    Where did you end up buying the VU4??
    I brought it all in a kit thru Dom .

    Leave a comment:


  • vdubin
    replied
    This is running one compressor thoe ?
    Cause im running two & have no where near 30ltrs

    Im affraid the wheel well will be where my subs going just worked out the plan for it then.
    My car will be for normal driving height then slamming for car shows & to park thats it.

    Leave a comment:


  • rayray086
    replied
    Where did you end up buying the VU4??

    Leave a comment:


  • thestu
    replied
    Forgot to say! It takes about 2:40 for fill from 0-145

    Sent from my GT-I9000 using Tapatalk

    Leave a comment:


  • thestu
    replied
    Takes 33 seconds to fill a 30lt tank from 110 to 145. I would run a flat panel over that wheel well dude you will get quite a lot of air in there! lines are easy to run where ever

    Best bet is to run the rear air lines through the top of the strut tower... the fronts run them above the fuel tank and into the boot be careful not to but holes in structural stuff!

    Stu



    Sent from my GT-I9000 using Tapatalk

    Leave a comment:


  • vdubin
    replied
    Originally posted by VW Imposter View Post
    I'm jealous of all these awesome set-ups, square tanks look bouse too.
    Cheers man.

    Originally posted by thestu View Post
    Make a tank from the wheel well? Put some plate over the top and weld that sucker shut!
    Haha Tempting but my air lines may be coming from the wheel well And I still need to work out where my subs going (I dont want it to take your eyes away from the tanks) Depending on the price for a pancake tank I may skip it I have two compressors so it shoud refill quick.


    Originally posted by fatmir305 View Post
    this is awesome man. love the tank setup.
    originality!

    and more cars on air in aus is always awesome
    Thanks fatmir, Im sure I commented on your ride on Air society, An Air bagged EOS in OZ thats DOPE!

    Leave a comment:

Working...
X