If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
put the cv's/axles in, completed all the engine wiring and hoses (minus the heater hoses), got the front coilovers in, finished mounting the exhaust...and then we started it
took a while to start cause the electronic ignition must of been stuffed so we swapped it for points and it starts first turn, sounds awsome too...will get a vid up soonish...
put the cv's/axles in, completed all the engine wiring and hoses (minus the heater hoses), got the front coilovers in, finished mounting the exhaust...and then we started it
took a while to start cause the electronic ignition must of been stuffed so we swapped it for points and it starts first turn, sounds awsome too...will get a vid up soonish...
yeah probs should of put this below the pics, but had it running late yesterday....still got a few things to finish up but it kicks over first go, very happy with it!
got the car running properly today, made up all the heater hoses and got some coolant in...it all works well only this is the heater tap is a gone so i was leaking need to find another
took a while to get the 5-speed done properly but its all sweet now and selecting gears very easily which is good..
still have to get the timing done better but have to wait till i get a better dizzy which should be soon..other than that mechanically its looking good...
also made a start assembling the doors and hoping to start looking at the interior now...
just took a quick vid, motor still needs the timing done and a tune but its running ok for now. I got a better dizzy and coil which I want to put in soon. other than that not looking to bad...the sound quality is so **** when i uploaded it which sucks.
the body is very straight panel wise but the paint is not immac, just want it to be 100% mechanically for now and then worry bout a closed door or something down the track but I have treated and cut out/welded all the rust earlier...but i dont think once its on the road it will be enough of an issue to make me do it lol probs be more concerned with ripping 2nds...(on a close road of course)....
started organising the doors too, so hopefully after the engine is completely finished, the interior can get some attention...
Tweet
Comment