If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
Griffiths Engineering spent some time on the car yesterday - dialled in the exhaust hangers and sorted out the new seating arrangements.
On the list to do before I slow down somewhat and enjoy it are;
Idler and adjustable cam pulleys/tune to match
Refurb door cards
Install gauges in DIN panel (Volt, Oil Pressure, Water Temp)
Custom intake pipe and breather diversion to catch can
Further guard flaring/rolling
New and stiffer engine/gearbox mounts
New front and rear plastic bumpers
Open single headlight grille
Paint some components under the hood to tidy it up a little
Possibly remove and replace the tints
Comment