If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
A SWL error occurred and now the Maximum SWL Error Count has been reached. SWL is now blocked until a power cycle is instigated using the following 3 buttons:
Europe, China, Japan: SETUP, MIC, EJECT
North America Region: GUIDE, Day/Night, EJECT
North America Hybrid: CAR, Day/Night, EJECT
So im guessing Australia falls under the Europe, China and Japan one? As I dont see a GUIDE, Day/Night or Car button mentioned on the unit.
MK6 GTI 3 Door - Candy White - DSG - Sunroof - 18" Detroit - ACC - PA - RC - MDI - BT - RNS510.
Could clear that by going into the "secret menu" (Hold "SETUP" for about 15 seconds...) In the secret menu, you will see the option to clear memory/errors (or similar)
Anyone re-installed one of the boot logos at 402x firmware? Have only tried twice but it reports a SWL error. Haven't had a chance to do any debug yet just wanted to see if its my issue or a more general one...
2011 Skoda Octavia vRS TDI DSG wagon|Revo Stage 1|Race Blue|Leather|Dynamic Xenons w 6000K|9w7 BT|THA475 Amp+active sub|Whiteline ALK|RVC| 2009 R36 wagon|Biscay Blue|RVC|Tailgate|ECU and DSG tune|LED DRL/Indicators|3D colour cluster|Quad LED tail rings|Climatronics upgrade|Dynaudio retrofit|B7 RLine Flat Steering Wheel|3AA CCM|TPMS Direct|B7 Adaptive Cruise with Front Assist|Discover Media retrofit|PLA 2.0|Lane Assist|BCM retrofit|High Beam Assist|DQ500
Anyone re-installed one of the boot logos at 402x firmware? Have only tried twice but it reports a SWL error. Haven't had a chance to do any debug yet just wanted to see if its my issue or a more general one...
Hey karnold, I did this today, just put the cd in, ran it, it gave a swl error saying it was a downgrade. I then pressed the reset sequence, and it installed just fine
Firstly,thanks John for your work. Prior to updating to FW3810, I had no problems applying your boot screens. But after 3810, I can't get them to load. I've tried everything I can, burning at x1, allowing downgrade, and rebooting, but I still get this
Firstly,thanks John for your work. Prior to updating to FW3810, I had no problems applying your boot screens. But after 3810, I can't get them to load. I've tried everything I can, burning at x1, allowing downgrade, and rebooting, but I still get this
Comment