hey all
im planning on doing some minor maintenance stuff on the car (changing brake pads) but looking into it because of the electric handbrake the car needs to be put in maintenance mode to release them.
is there a tool available so i can get this and other small jobs done?

Just in the process of installing the new DMF and clutch kit . Does anyone have the installation tool available to hire in Melbourne/Geelong ?
Thanks for any help or direction ,

Cheers .

my daughter just bought her first car VW polo 2010 it occasionally has the engine light come on and then sometimes goes into limp mode. unfortunately every time we plug a scan tool into it there are no errors found. We took it to a service center who also came up with nothing on the scan tool but advised...

Need to replace my battery, don't have a scan tool. Would appreciate if someone in Canberra with VCDS / OBDEleven could help me out?

My transmission is leaking & was only noticed after the plastic panel was removed for an oil change.
I haven't had time to find the leak yet but I need to check & fill the oil to the correct level.
Some time ago I purchased the special tool probably 2 years ago & now when I...

Hey,

First post here and probably one of many... I was reading erWIN for the removal of a sump on a 3.6 passat and saw it requires specialty tool T40159 to remove 3 bolts on the gearbox side (I believe its an extra long triple square round-head M8 to reach past the flywheel).
...

Hi all,

Just when I thought the looming MMI problem is gone for good... it came back!!

Yesterday I found someone with ODIS to scan the car and the error code 00384 popped up, unfortunately we couldn't dig out much more information as to which particular module failed on the...

Rear brake piston wind back tools - what a minefield.

Seemed a waste to pay$30 to $300 for a tool that gets used once every several years.

So I ended up with a <$15 Toledo brake piston cube from Total Tools. Doesn’t quite fit out of the box but a little reengineering...

Removing front inside door panel (door card). All okay so far removing four screws (two hidden behind pop-off trim panel on armrest), but the tool I have to pop the door pane just flexes and just won't budge the clips! The panel has 6 decent sized interior clips holding it on now (panel never removed...

Hi all,

I've done a couple of days of searching, googling, youtubing and scouring what workshop manuals I can find.

I'm struggling to find any info on changing power steering fluid/filling reservoir.

Long story short, my 2016 amarok squeeling when its cold....

Does anyone in Brisbane have a MK6 GTI crank pulley tool I can borrow for a case of beers?

I'd like to tackle the timing chain tensioner ASAP as it's started to rattle a fair bit.

PM if so

Cheers

Does anyone in Brisbane have a MK6 GTI crank pulley tool I can borrow for a case of beers?

I'd like to tackle the timing chain tensioner ASAP as it's started to rattle a fair bit.

PM if so

Cheers

changing the cam tensioner on my mk5, need the tool to remove the cam. Willing to pickup and also pay to borrow.

**SOLD**

MANN oil filter removal tool (suits 1.8TSI and 2.0TSI engines (era 2009-2014) with the oil filter that sits on the top of the engine (drivers side) just to the side of the inlet manifold. Only used a few times before i sold the car. Handy tool to have if you DIY oil changes....

Hi guys,

I am aiming to replace the timing chain on my 2010 GTI in the next couple of weeks and I don't have access to the cam valve (N205) removal tool.

I was planning on purchasing one through Amazon but since the government change the import laws it seems much more difficult...