If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
Factory radio MADE IN KOREA !!!!!!! Yes that connector is for can bus it shows it in the diagram the holes on the right are the speaker connections shown as LF - LF + RF - RF + and so on these can be plugged to your new unit but you may have to use some electrical spade connectors . I would suggest a CAN BUS connector with your new unit just in case . The older T5 has direct wiring that means there was an earth wire a continuous positive for memory an accessory wire plus lighting and some others that I now forget what they did If I get a chance I,ll have alook at mine and let you know .Howard
Tweet
Comment