did you check that cylinders injector seal?
Above Forum Ad
Collapse
Announcement
Collapse
No announcement yet.
Rough/hunting idle, coil dying?
Collapse
X
-
Originally posted by sambb View Postmines always had a funny idle too. rock solid and then will suddenly dip big time. Not in an A/C or ancillaries switching on kind of way - much worse than that. When I pull out my SAI pump I'm going to change the PCV valve and check all the hoses whilst I'm in there. They are a common culprit often apparently.Cheap, Fast, Reliable. Choose two.
Comment
-
I've also had issues with the idle being a bit off in the past also. Never really had any solid evidence pointing towards any one thing. Being that I have bigger injectors that could be part of it, and mines only ever when cold, once warmed up the bigger injectors idle perfectly. When I had stock injectors my idle was always pretty bang on.2006 GTI Polo - Big Turbo Build - Louis19's Build Thread
Comment
-
Originally posted by rgvlee View PostMy running temps the other day were a bit below normal as well.
I am fairly sure at the moment my issue is one cylinder.2006 GTI Polo - Big Turbo Build - Louis19's Build Thread
Comment
-
My Car also used to hesitate/run rough at low speeds, and idle rough when I had an issue with my MAF plug. One of the terminals was to far apart to the MAF sensor pins didn't have a proper connection intermittently and used to get a MAF code because of it. Just another possibility, but again would need a scan to confirm.2006 GTI Polo - Big Turbo Build - Louis19's Build Thread
Comment
-
Originally posted by louis19 View PostThermostat stuck open? When mine was stuck open it would take forever to get to temp (even summer took longer then it should) and then would drop when cruising in winter. Correct me if I'm wrong but I think the car dumps more fuel in when the car isn't getting to temp, in the attempt to try and get the temp up?
It's getting up to temp as normal but when running sitting a bit below norm.
I'll get the exact numbers this weekend when I hookup the data logger.
No cel/obd codes being thrown08 9n3 Polo GTI
Mods: heaps
Comment
-
Rough/hunting idle, coil dying?
Just changed my thermostat and coolant temp sensor (I did them for other reasons), still doing it. I'm guessing that it's ignition related since the car sounds like it's running on less than 4 cylinders.
Sent from my iPhone using TapatalkLast edited by Blue9N3; 11-08-2016, 08:21 PM.
Comment
-
Finally all my gear has arrived
VCDS cable took ages even though it was sent express. Doesn't help when the seller sits on it for a few days.
Will buy the vcds lite and log block 032 what I am I looking for? Just log at idle or go for a drive?
The 2.0T coils rocked up today
Will dig out my sai blanking plate and get stuck into it this weekend
One thing at a time and see if I can isolate the issue08 9n3 Polo GTI
Mods: heaps
Comment
-
Idle is fine. If the values are more than 10% save them and reset the ecu by clearing the fault codes, even if there aren't any.
That will zero the trims so you can see if there rocket out of limits. Indicating a leak.
Gavin
Comment
-
Originally posted by rgvlee View PostFinally all my gear has arrived
VCDS cable took ages even though it was sent express. Doesn't help when the seller sits on it for a few days.
Will buy the vcds lite and log block 032 what I am I looking for? Just log at idle or go for a drive?
The 2.0T coils rocked up today
Will dig out my sai blanking plate and get stuck into it this weekend
One thing at a time and see if I can isolate the issue
Yell out if you get stuck.Track Car: 06 Polo GTI Red Devil mkII
Daily: 2010 VW Jetta Highline
Gone but not forgotten: 08 Polo GTI
** All information I provide is probably incorrect until validated by someone else **
Comment
-
So while waiting for the laptop to charge and trial the cable/shareware software I changed the coils out (2.0t coils and ecs bling) and did the crc check on the intake
It ended up being a stuffed pipe connected to the intake manifold. Must have been getting progressively worse
All fixed!
Will still do the other things I was going to do anyway08 9n3 Polo GTI
Mods: heaps
Comment
-
Originally posted by rgvlee View PostSo while waiting for the laptop to charge and trial the cable/shareware software I changed the coils out (2.0t coils and ecs bling) and did the crc check on the intake
It ended up being a stuffed pipe connected to the intake manifold. Must have been getting progressively worse
All fixed!
Will still do the other things I was going to do anyway
Comment
2025 - Below Forum
Collapse
Comment