What have you done to your mk4 (golf/bora) today?

[funkymonkey]

Boser hood extension is now complete, although with the welded on metal + bog to smooth etc my bonnet is a bit heavier and my hood strut doesn't support the weight (I could have had a wonky strut to start with that just managed to push it up.)

Is anyone aware of an OEM strut that can be used from a car with a heavier bonnet (maybe a car with a straight 6 so has a heavier steel bonnet?), that's rated for higher weight. Happy to deal with potential uppercut from bonnet release.

[blackers10]

you can get them recharged with a little higher pressure in them

[funkymonkey]

you can get them recharged with a little higher pressure in them

oh yeah! didn't even think of that!

[dylan8]

Strut might be stuffed?

[funkymonkey]

Strut might be stuffed?

Might be. Gonna see if I can get it regassed with nitrogen at a higher pressure, and see if that does the trick.

[Back Door Shenanigans.]

Might be. Gonna see if I can get it regassed with nitrogen at a higher pressure, and see if that does the trick.

Let us know how you go. I have the same problem, it stays open but any little bump or touch it will drop.

[funkymonkey]

Let us know how you go. I have the same problem, it stays open but any little bump or touch it will drop.

Reading this page on Strongarm's website, all we have to do is weigh the bonnet in kg (while hinged), then multiply it by 11 and round up. That should give us the torque that the gas charge needs to exert to lift the bonnet.

[Feeine]

roof racks. also potato cam 3000

[dcups(dailymk4)]

^^ nice one! Aristo's look brand new!

[danegti]

Gas struts are measured in newtons, it should be marked on it say for example 300N then just get a pair with an extra 50-100N. Make sure theyre the same length fully extended


Sent from my iPhone using Tapatalk

[blackers10]

fitted up a Sachs clutch and G60 single mass flywheel to my mk4 GTI. the new clutch has a very light feel under foot which is nice in traffic and the lack of clutch slip and Dual Mass Flywheel backlash is fantastic!
I can finally enjoy full boost with my K03s and stage 2 Custom Code tune

next up is replacing all 4 brake rotors and pads and fluid and new front control arm bushes

[funkymonkey]

Stubby mirrors are on and found a badgeless grille on fleabay to cover up the badge dent in the bumper. Will put the proper grille on when I fit up the modded R32 bumper.

[Ald]

What brand rotors and pads did you replace with?

where did you get the springs and shocks? What was the price ? I am think of doing exactly the same as you did on my Bora v5

[BLN355]

Did a plug change on the Bora. They were filthy and the reason for my bummy top end, now i understand the enjoyment of the VR6

[ffoff]

Can't sell the wheels so I might as well run em!