If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
Above Forum Ad
Collapse
Announcement
Collapse
No announcement yet.
Please HELP with RCD510 with 9w7 retrofit for T5 Caravelle
If you coded 77 with VCDS then it should show up But then again I think you said you didnt have steering wheel controls? If not then it wont show as you have no way to control the data in the display.
sorry...didn't notice your comment re the MKVI wheel.
in short...not sure if that will be enough to get the mfd to kick in with more info. The techo's will know if that is enough, or if the mfd 'module/control will require some 'tweaking'.
My comment was based on the Polo wheel, which has volume controls etc on left hand side, but no controls on the right. MFD is controlled off the wiper stalk.
No need for right stalk as the t5 uses the same bus as a polo so all the programming is done at the bcm. After fitting the mk6 standard mfsw (not gti, so I didn't need a new airbag) I had to get a new airbag loom connection. The buttons still not working even after I completed the Lin connection and the 12v. I'm suspecting a faulty airbag loom ATM. Will keep you posted
Hi guys, changed over the airbag loom, and still no good. I started suspecting that maybe I needed a different stalk switch so I have swapped it over for the BA version (with cruse on the left stalk), still no good. Now I'm losing my mind... Help....
Comment