NSW 02a, 02j and 02r Pinion Shaft Braces

[Schalke04]

Out of stock for the moment. If there's more interest I'll get more made

Will have a few gearbox pinion shaft braces for sale. Basically secures the pinion shaft to the bellhousing so it's less likely to flex under load, it's a must for high HP cars. This will work on mk3 vr6, mk4 Gti and polo 9n Gti. Will also work on all other 02a, 02j and 02r gearboxes.

These will be ready in the next week or so. I have a certain amount being made so first in gets them

Will be $100 each or very close, plus postage. First in first served, unless an arangment has been made for a later payment.

Actual item pictured

[Schalke04]

No interest on here? About 10 of the 20 being made are spoken for. 10 left

[vwthunder]

Im in, if you haven't already put me down, guessing it will fit a polo

[Schalke04]

Im in, if you haven't already put me down, guessing it will fit a polo

Assuming we spoke on Facebook. If so more than likely have you down already

[Notso Swift]

Where does it become an issue on these boxes?
I thought they were good well past 300 ft.lbs.

[Schalke04]

Where does it become an issue on these boxes?
I thought they were good well past 300 ft.lbs.

It's a must for high HP cars, but it's also a good idea for tuned or stock cars. Strengthens the weakest point in the bellhousing and could save you a big gearbox repair bill in the future

[aprr32]

Yep,I'll take one aswell

[rgvlee]

Umm ok put me down.

[Schalke04]

Added you both to the list

[Schalke04]

Ok I have these in stock now. Please pm me if you want one and i can get them sent once payment has been made

[Schalke04]

Pictures added

[Schalke04]

Sold quite a few. Not many left, so pm me if you want one

[Schalke04]

Back in stock!

[Corey]

Back in stock!

Hi could I please buy 2! double checking they will fit polo tdi 02r 5 speed?

Thanks

[sambb]

Yep it will. I just fitted one of Schalke04's braces to my 02R (which uses the 02J bellhousing) in the polo 9n3 gti. You will have to file some parts of the brace and bellhousing to get it to fit dead flush. I just did it with hand tools and its no biggy. That's also totally normal too - the castings on the bellhousings all have variations in them so you have to account for that.