I've looked at the kits for increasing wading depths in a T5/T5.1 These seem amazingly overpriced. I've also looked at some generic kits.
Has anyone got the dimensions of the breather on the DSG auto transmission (vehicle as below). I'm pretty sure the part no is something like TF60SN 09G. It...
Above Forum Ad
Collapse
Announcement
Collapse
No announcement yet.
Search Result
Collapse
133 results in 0.0424 seconds.
Keywords
Members
Tags
-
Wading depth again
-
Transmission status - Not registered?
Hi all,
I can't remember the last time I ran a scan but ... the other day I was surprised to find the following entry under:
Auto Trans - Status - Not registered - 0001
The car seem to be driving/changing gears Ok though with the mileage on the clock there are these...
-
Replacement Transmission VW Bora
Replacement Transmission VW BoraHi everyone, MIG has suggested posting this on the Mk4 Forum to see if somebody can help, so thank you for any help....
I am new to the Forum, just joined so pretty excited to be part of the group. This is my first car group forum so forgive my lack of knowledge.
-
Replacement Transmission VW Bora
Hi everyone, I am new to the Forum, just joined so pretty excited to be part of the group. This is my first car group forum so forgive my lack of knowledge. I have a 2003 VW Bora v5 2.3L , which i have owned for 15 years, it has served me pretty well, bar a few cheeky problems and electrical gremlins...
-
Mk 7.5 TCM Coding
Hi guys
I'm located in Caroline springs (melbourne) and have just installed a new transmission (dq381) into my golf r 7.5. Now it's reads that the transmission is locked and I'm needing to code my new gearbox to my ECU and BCM.
Do you know anyone that offers this service...
-
Scrapping my 2013 Golf
Hi Folks - I will be shortlyposting a complete message in the Golf forum. I have been the happy owner of a 2013 Golf Highline auto hatch.
Both the mechatronic and the transmission died! Only found out about the transmission after buying a new mechatronic.
Full post to come...
-
Metal filings in DSG filter?!
A little bit concerned… Just had the big 120k service done on my Golf Alltrack TSI. Mechanic found a small amount of metal swarf in bottom of the filter when changing the transmission oil. The pieces are minuscule — maybe 1-2mm across, small metal filings. They’re quite fine to the point where...
-
New Member
Hi! I'm in Sydney and I've just bought my first VW.. a 2016 GTI 40 Year Anniversary with a manual transmission. So much fun!Last edited by zander35; 08-11-2023, 07:31 PM.
-
T5. 4motion slave cylinder replacement
Ok so she’s in pieces after constant loss of clutch pedal. Replaced clutch master bread many times. Clutch comes back but after a drive goes again. Replaced breather and o rings So must be slave cylinder right. ( concentric clutch release bearing. ) Big job -
subframe off
dpf out...
-
New rims
19x8.5" Inforged rims fitted with 245/40R19 Pirelli's. H&R springs have been ordered by my local VW tuning specialist. Still waiting for APR to supply the transmission tune file
...
-
MK6 TDI Golf DSG O2E Slipping Grinding Hard Shifts Clunking
Hello VWW members,
I hope this post finds you all well. I'm currently facing some DSG issues with my 2009 Golf MK6 TDI (Engine Code: CBAB) equipped with the O2E DSG DQ250 Transmission, and I'm reaching out to the community for some guidance and suggestions.
Here's a brief...Last edited by sto; 12-10-2023, 01:52 PM.
-
Tiguan 2017 Transmission failure
Hi Everyone
I found this site because I was looking for information about a transmission issue my 2017 Tiguan R-Line has. I bought the car late 2017 in Wollongong and loved it. I always felt the gear changing was a bit juvenile ( not smooth and very noticeable), but I had no reason to think...
-
Is the forum dead? 😅 Help with fault codes/ diagnosis please
Hey everyone, I have a Golf mk6 2013 1.4l
It’s having issues with the transmission where it goes into limp mode within the first few kms (the car loses all power and needs to be restarted) and then I can restart the car and it drives fine, though sometimes it does it multiple times....
-
Looking for gearbox valve body rebuild kit.
Hi, I've got a 2008 VW Polo Match 9N3 (or 9N) 1.6L. The valve body in the gearbox is on the way out and I'm looking for a rebuild kit except I can't seem to find one anywhere. Has anybody come across these and know where to get one?. I've been told the gearbox code is JUF but to be honest I'm not s...
-
2025 - Below Forum
Collapse