I have a question that others may be able to answer about the tiptronic.
Its a bit difficult to describe so bear with me.
Recall that some autos have lock up torque convertors, and when they lock the torque convertor slip you can detect a drop of revs in the order of about 500 rpm, this was very noticable on the RAV4 4spd where it would unlock as load was increased like going up a hill, then when load reduces it would lock again. Similairly when going through the gears, the gear would change firmly then a few seconds later you could notice the extra rev drop when the torque convertor locked.
Back to the tiptronic; When mine changes up after starting off in 1st it will change firmly to 2nd with no flare, and no other rev change, but when it changes into 3rd it changes firmly again, then about 3 seconds later the revs drop about 500rpm, with no flaring up of revs at any time, then into 4th same as second just one single operation, same for 5th and 6th.
This double rev drop is the only odd thing I notice about it. I have reset the controller a couple of times and it makes no difference. I can't find any technical detail on how it should work, and I am fairly sure it has always done this from new.
If anyone knows anything technical about these boxes could you give an opinion on this operational behavior.
Thanks
Brian
Its a bit difficult to describe so bear with me.
Recall that some autos have lock up torque convertors, and when they lock the torque convertor slip you can detect a drop of revs in the order of about 500 rpm, this was very noticable on the RAV4 4spd where it would unlock as load was increased like going up a hill, then when load reduces it would lock again. Similairly when going through the gears, the gear would change firmly then a few seconds later you could notice the extra rev drop when the torque convertor locked.
Back to the tiptronic; When mine changes up after starting off in 1st it will change firmly to 2nd with no flare, and no other rev change, but when it changes into 3rd it changes firmly again, then about 3 seconds later the revs drop about 500rpm, with no flaring up of revs at any time, then into 4th same as second just one single operation, same for 5th and 6th.
This double rev drop is the only odd thing I notice about it. I have reset the controller a couple of times and it makes no difference. I can't find any technical detail on how it should work, and I am fairly sure it has always done this from new.
If anyone knows anything technical about these boxes could you give an opinion on this operational behavior.
Thanks
Brian
Comment