If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
I'm getting my H&R monotube coilovers (hopefully it comes with shorten drop links) and will get it installed plus corner weighting and geometry corrections soon. Will do a review soon
done a couple of recent track runs on a fairly elevated track which really shows up all the flaws of a fwd car.
The second run I had the rear on medium and the front changed also to medium from soft and I think it's the closest i'm going to get to a completely neutral balance on the the Devil. Never before seen so much turn in and no understeer. And the most grip i've ever had from a takeoff and cornering. I also have a Forge strut brace and a Wiechers steel lower brace so the front end is very tight now especially with the sway on medium. I dare say If I went with damper adjustable coilovers and dialed a slightly harder setting on the fronts it would be go cart like experience. Oh and from what i've read the light weight rims help with turn in and feedback also. It was fun disposing of a few Golf R's too
done a couple of recent track runs on a fairly elevated track which really shows up all the flaws of a fwd car.
The second run I had the rear on medium and the front changed also to medium from soft and I think it's the closest i'm going to get to a completely neutral balance on the the Devil. Never before seen so much turn in and no understeer. And the most grip i've ever had from a takeoff and cornering. I also have a Forge strut brace and a Wiechers steel lower brace so the front end is very tight now especially with the sway on medium. I dare say If I went with damper adjustable coilovers and dialed a slightly harder setting on the fronts it would be go cart like experience. Oh and from what i've read the light weight rims help with turn in and feedback also. It was fun disposing of a few Golf R's too
front sway can add a lot of traction and make the ride stiff. I'm not sure of the direct difference between stock and the fsb as I had coilovers and a bunch of other bits done at the same time.
If you are keen, I'd suggest looking towards a LSD and sticky rubber for the front end.
The much cheaper FSB can certainly help keep more weight on the inside wheel.
front sway can add a lot of traction
...
The much cheaper FSB can certainly help keep more weight on the inside wheel.
Unless you have enough body roll to cause serious camber issues, an anti roll bar does the opposite - you lose grip with the extra roll stiffness as weight gets transferred from the inside wheel to the outer one.
Unless I've misinterpreted your comment and you are talking about using an aftermarket front antiroll bar that has lower stiffness than stock.
What greater roll stiffness does give you is better steering response.
10+ years in hot Minis has certainly taught me how to drive a FWD car fast, and without being all over the shop. I don't scrub/squeal/understeer/run out of brakes or anything like that.
I have no LSD, no rear sway, no toe adjustments. just the Bilstein cup kit, some poly bushes in the rear, and some added castor in the front.
It just takes time and practice, and usually less right foot.
Have you got some added castor in the front of yours?
No added caster yet, got the camber tops going in this week, camber/caster.
Did a track day and seemed to have lots of understeer, with the RSB set on hard, the rear stuck like glue. I have been told the toe correction on the rear will make the car more neutral
If you're rear wheels are pointing straight/slightly outward, as the weight leans onto the outside tyre, the back of the car will want to track 'out' - ie oversteer.
What suspension are you running? Does it have any movement, or is it just bloody stiff?
Camber will reduce your inner wheels' contact patch. Castor has no effect on static (straight ahead) camber, but adds more, the more lock you turn in.
Comment