New Polo problems - Register

[danielv10]

Over the past two weeks my Polo has started to develop two rattles. One was behind the dash in the engine bay and other in the B pillars on both sides. Thanks to 77kw polo TSi's post I was able to isolate the two pipes which caused the dash rattle and taped them thus fixing it

I had this annoying rattle coming from somewhere in front of the dash, behind the steering wheel, and wasn't sure whether it was inside the cabin or inside the engine bay. Of course it only happened intermittently and only then with my foot on the brake and it in drive.

That is until this week, when it kept making the noise whilst in park, jumping out the car at a carpark I traced the noise to inside the engine bay, and discovered these two pipes going down into a metal cavity, just behind the round radiator expansion tank (ball). I fund they were raised and didn't seem 'fixed' via any clips. Pushing them down into the cavity stopped the rattle. If it stays 'stopped' I'm going to push a piece of foam into the cavity to hold them tightly in place.

Picture of cavity and pipes...

However, the B pillar rattles are getting worse and worse now and I haven't had a chance/lazy to take it back to VW for them to look at. From Gavs's post a while ago, I suspect I may have the same thing. Is it wise, or feasible to try play around with the door striker?

Ok, resolution to my rattles.

Rattle 1:
Rattle occurs, especially over poor roads in the passenger side B pillar, tried playing with seatbelt adjuster as that sounds like the correct place but to no avail.

Solution 1:
Front passenger door striker was loose and over uneven road was transmitting rattle up, through the hollow section of the B pillar. After adjustment, not only is the rattle gone, but the front passenger door internal and external handles feel tighter and more tactile to operate.

[MJKooLio]

Just update the dealership with my engine light appearance last night and he said to bring the car in and that "You don't want to do any further damage to the engine" Further damage to the new engine or?????

[ATYPIC]

Just update the dealership with my engine light appearance last night and he said to bring the car in and that "You don't want to do any further damage to the engine" Further damage to the new engine or?????

Is it the engine light or the actual oil pressure light?

Dealerships have a certain way with words too.

[MJKooLio]

Is it the engine light or the actual oil pressure light?

Dealerships have a certain way with words too.

With words huh? Same as calling me up saying that the parts for my car are in when they have been going on about me getting a new, completely new engine? Then me questioning "so parts or a new engine?" And they go apologizing saying 'new engine'. Again, very suss if I got a new engine or NOT!!!! Block and Pistons just replaced? Still have to take my car to another dealer to check it out

[cyborgcuprajq]

With words huh? Same as calling me up saying that the parts for my car are in when they have been going on about me getting a new, completely new engine? Then me questioning "so parts or a new engine?" And they go apologizing saying 'new engine'. Again, very suss if I got a new engine or NOT!!!! Block and Pistons just replaced? Still have to take my car to another dealer to check it out

You didn't ask them to show you your old engine?

[MJKooLio]

Good point...

Spoke to the other dealer that I'll take my services to and they said the new engines don't get new engine numbers and use the old one.... So that's two dealers...

They also told me to take the car to the original dealer as they recommended as the engine light appeared yest.


Today the car drove fine!

[Umai Naa!!]

Over the past two weeks my Polo has started to develop two rattles. One was behind the dash in the engine bay and other in the B pillars on both sides. Thanks to 77kw polo TSi's post I was able to isolate the two pipes which caused the dash rattle and taped them thus fixing it



However, the B pillar rattles are getting worse and worse now and I haven't had a chance/lazy to take it back to VW for them to look at. From Gavs's post a while ago, I suspect I may have the same thing. Is it wise, or feasible to try play around with the door striker?

Try loosening the latch mechanisms off (Using an 8mm multi-spline), and coating them with contact lubricant, and tightening the 'F' out of them.

I've found this to be very effective on a lot of the current VWs.

[Umai Naa!!]

Rebuild vs New are pretty different. To my knowledge, when they say "new engine" which is happening all over the world, they replace the engine block, pistons and rings etc which to me would constitute a new engine number. Clearly not though...

I'm not within the dealer network anymore, but I'll try and get an answer tomorrow on the whole thing.

VW must be pretty good dealers to do an apprenticeship with. With other makes you would only learn to fit accessories and change filters, the occasional timing belt. Getting to do engines, clutches and gearboxes would be pretty special.

VW have their own apprenticeship scheme, where the apprentices are trained by VW. I'm told it's been very successful so far.

The level of participation that an apprentice may have within the workshop varies from dealership to dealership, and from one apprentice to another. A lot depends on their perceived capabilities. I had two that were polar opposites working under me. One needed their hand held most of the day, while the other one you'd have to tie to the bench. Too keen for my liking! I preferred the timid one! One has turned out to be quite handy on the tools, while the other one had to bail out due to personal reasons.

[danielv10]

Try loosening the latch mechanisms off (Using an 8mm multi-spline), and coating them with contact lubricant, and tightening the 'F' out of them.

I've found this to be very effective on a lot of the current VWs.

Thanks for that. I'll have a fiddle with it this weekend

[cyborgcuprajq]

So when they say new engine can also mean just new head?

[Gusman]

VW must be pretty good dealers to do an apprenticeship with. With other makes you would only learn to fit accessories and change filters, the occasional timing belt. Getting to do engines, clutches and gearboxes would be pretty special.

And here I was thinking you were taking the p!ss re. VW's various quality issues....

[MJKooLio]

And again tonight at 60kp/h and 100kp/h the car studdars and feels all shaky. Haven't had time to take the car back to dealer ... How do go getting a new god damn car?! Engine change 1 done but still issues???? I say engine wasn't replaced! Anyone have ideas on how to approach this as well as Consumer Affairs and me working in the media?

[kawabanga]

I don't know how to approach this problem there in Australia, but for sure I'd write an email to the following address, explaining every detail, they usually answer quickly and they will assing you a ticket #

kundenbetreuung@volkswagen.de

.

[m@kro]

after 30.000 kilometers yesterday i replaced the dual clutch dsg transmission. the problem was at the 2 gear has vibrations.
the damage was on garandi.

[prcurrie]

And again tonight at 60kp/h and 100kp/h the car studdars and feels all shaky. Haven't had time to take the car back to dealer ... How do go getting a new god damn car?! Engine change 1 done but still issues???? I say engine wasn't replaced! Anyone have ideas on how to approach this as well as Consumer Affairs and me working in the media?

MJKooLio - have a read of this http://www.consumerlaw.gov.au/conten...tees_guide.pdf

The laws have gotten easier for consumers with 'lemon' products!