Hey,
The new R36 that I have is mostly fine as it stands; however.
I'll go over what I have covered so far.
I was having issues with the DSG being lurchy from a standstill; it'd drive fine and shift fine. However I did some research and did a DSG reset via VCDS to see if it helped and it is a lot better. I am also going to get a DSG service as well within the next week or two.
VCDS is picking up these errors still; Which I need to diagnose and determine so I can get them covered under warranty. Obviously I will make a mechanic aware of it and we can go from there.
The other one I have been getting is this; however since changing the oil and doing a reset today and driving it for say 10-20 minutes it hasn't come back as it did. I am going to do a casual drive somewhere later and check it.
This also appeared today for the first time; I do have the GruppeM intake kit on the car as well; Cleared it as above and didn't come back after a 15-20 minute drive so I guess I'll see.
The last parts of my dillema are smaller annoyances.
1. Is it possible to get keys done anywhere apart from the dealer? $600 it steeeep.. I found someone on ebay but he requires to de-solder the eeprom chip and dump the contents which is out of my skillset and I'd rather pay the $600 at that point since he's still a bit over $200 for each key.
2. Does anyone have/know where to buy some lug bolts that are tapered and 35mm long? Bob Jane can't seem to find anyone in the country with 20..
The new R36 that I have is mostly fine as it stands; however.
I'll go over what I have covered so far.
I was having issues with the DSG being lurchy from a standstill; it'd drive fine and shift fine. However I did some research and did a DSG reset via VCDS to see if it helped and it is a lot better. I am also going to get a DSG service as well within the next week or two.
VCDS is picking up these errors still; Which I need to diagnose and determine so I can get them covered under warranty. Obviously I will make a mechanic aware of it and we can go from there.
Code:
01117 - Generator Terminal DF Load Signal 008 - Implausible Signal - Intermittent Freeze Frame: Fault Status: 00101000 Fault Priority: 6 Fault Frequency: 4 Reset counter: 163 Mileage: 165497 km Time Indication: 0 Freeze Frame: ON Voltage: 12.60 V ON ON OFF OFF OFF
Code:
01629 - Sensor for Parking-Aid; Front Left (G255) 009 - Open or Short to Ground Freeze Frame: Fault Status: 01101001 Fault Priority: 3 Fault Frequency: 1 Reset counter: 118 Mileage: 165497 km Time Indication: 0 Date: 2019.03.06 Time: 19:35:19 Freeze Frame: Temperature: 20.0°C 01627 - Sensor for Parking-Aid; Front Mid-Right (G253) 009 - Open or Short to Ground Freeze Frame: Fault Status: 01101001 Fault Priority: 3 Fault Frequency: 1 Reset counter: 118 Mileage: 165497 km Time Indication: 0 Date: 2019.03.06 Time: 19:35:19 Freeze Frame: Temperature: 20.0°C 01549 - Supply Voltage for Parking-Aid Sensor 002 - Lower Limit Exceeded Freeze Frame: Fault Status: 01100010 Fault Priority: 3 Fault Frequency: 70 Reset counter: 135 Mileage: 165460 km Time Indication: 0 Date: 2019.03.06 Time: 17:34:37 Freeze Frame: Temperature: 20.0°C
Code:
000011 - Camshaft Positioner (Bank 1 Exhaust) P000B - 008 - Slow Response - Intermittent
Code:
012408 - Throttle Control P3078 - 002 - Airflow at Idle too Low - Intermittent
1. Is it possible to get keys done anywhere apart from the dealer? $600 it steeeep.. I found someone on ebay but he requires to de-solder the eeprom chip and dump the contents which is out of my skillset and I'd rather pay the $600 at that point since he's still a bit over $200 for each key.
2. Does anyone have/know where to buy some lug bolts that are tapered and 35mm long? Bob Jane can't seem to find anyone in the country with 20..
Comment