Sat nav licence agreement always showing

[Dutch77]

..except I tend to mutter something else when it pops up. Not required today though - it was random not appear day.

[kennyc]

Since my last post the message has disappeared...
Haven't had it since Monday

[Dutch77]

Could be weather related given you're In Victoria and getting ours from Monday - two more trips x 2 today with no message, that puts me on a six drive streak of no message.

Perhaps we need to start a leaderboard.

[mgrobins]

The NAV message is irritating and the general feel I get from the other messages is that they are condescending and assume you area total moron. I'm sick of products being designed for the lowest common denominator. Think of the Children!!!!

Perhaps we can petition VAG to have a parental control installed enabling us to turn off the stupid reminders and messages....

[fontana302]

Surely there must be a VCDS tweak to turn this off?

With BMW's you can (using the equivalent to VCDS), so I reckon there must be a way.

[DV52]

Surely there must be a VCDS tweak to turn this off?

With BMW's you can (using the equivalent to VCDS), so I reckon there must be a way.

Fontana: Hello again. Yes, there is a (simple) VCDS tweak to turn-off the "nag screen". The original instructions were provided by Zloybob.

I've provided a link to Zloybob's tweak in my VCDS reference thread, but here's the "Open Controller" screen shot




Or, if you want to do it the easy way, here's the long coding helper screen shot of the pertinent byte. It's bye 23 of the infotainment control module (address Hex5F)- remove tick from Bit 2.



Cheers
Don

PS: Please note that when I did this tweak, I had to set-up the radio again (lost RDS and TP) . Not difficult to do, just need to be aware that it's a necessary step in the tweak

[bobcrusader]

What's the screen before this? I can't find the screens you are showing?

[DV52]

What's the screen before this? I can't find the screens you are showing?

Bob:

From the "Main" VCDS screen (below) click "Select"



Then click "5F-Information Elect" (see below"




Then click "Coding-07"



Then click "Long Coding Helper" - see 1st screen shot on my previous post
Go to Byte 23 (2nd last byte from RHS) - see 2nd screen shot on my previous post
Then remove tick from Bit 2
Then click the "X" on the top RHS of the long coding helper screen
Then click Doit!
Then close all the screens

Cheers
Don