If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
as i said, once the halogens are on, the leds don't show up on camera too well.
though they are very noticeable to the eye (on low beam) once high beam is on, not that noticeable.
here goes...
in order...
parkers only
low beam
high beam (showing off my new spotties)
the camera just can't capture the true look of the lights.
i will see if they show up any better on video (tomorrow)
if i were you, i would get a set of these LED's, as any halogen (incandescent) globe will look very yellow next to HID lighting.
i plan on changing to HID later (once i get a set of projector lights).
i have Narva Blue Power H7's fitted now, and they are heaps whiter than the stock globes.
the old stock parkers were very yellow. now i have the led parkers installed, the Narva's now look yellow in comparison.
so i guess i know what my Xmas bonus is going on..... (HID)
Jason.
When I say Xenon-Look.. I mean that the cluster looks like the Xenon's on the R32's etc.. The bulbs will be Halogen unfortunately..
Mate, I have about 3 pairs of them that I'll not use now with the dynabeams and the Celis light
Do you want them, Im happy to send them to you if so, PM your address,
Cheers!!
I may just take you up on that offer.. I will however wait until I get the new lights as I may take the plunge and go for orange park lights (to blend in with the indicator when it's on)..
as i said, once the halogens are on, the leds don't show up on camera too well.
though they are very noticeable to the eye (on low beam) once high beam is on, not that noticeable.
Jason.
You probs won't get a good photo of the actual bulbs unless if it's daylight.. It'll be good to see them!!
2002 Volkswagen Bora V5 - 2007 Mazda 3 GT - 1998 Ford Contour Sport - 2010 Volkswagen Jetta 2.0T - 2013 Volkswagen Passat 130TDI - 2015 Ford Escape 1.5 - 2016 Subaru WRX - 2018 Volkswagen Golf R Wolfsburg Wagon
yeah i've tried these on a bora couple of weeks back, but found them too bright and too white comparing to my lights. so now i went for some blue vision parkers.
how much were your dynabeams ?
i really want a set of those....
where did you get them from, and are they the correct beam pattern for RHD cars ?
Jason.
DynaBeams are available on the TM Tuning website along with a few other light styles. I've found that their prices aren't all that expensive depending on what you go for..
2002 Volkswagen Bora V5 - 2007 Mazda 3 GT - 1998 Ford Contour Sport - 2010 Volkswagen Jetta 2.0T - 2013 Volkswagen Passat 130TDI - 2015 Ford Escape 1.5 - 2016 Subaru WRX - 2018 Volkswagen Golf R Wolfsburg Wagon
yeah i've tried these on a bora couple of weeks back, but found them too bright and too white comparing to my lights. so now i went for some blue vision parkers.
Alright. So my GTI's dome lights are now all LED using the following in Pure White:
I have these in all 5 overhead lights; the center festoon between the maps lights [2006 MY FTW] was removed. Now onto the issue.
When I leave the lighting setting on 'door', the LEDs don't go out...
I discovered the Blesk / Maxlux LEDs when some VW owners in Europe posted about them - Brex buddy got them for me.
Use two of these in the license lights - total $26 shipped in US -
Plug and play - no resistor needed - simple bulb swap ...
The packaging is labeled Blesk, the bulb is labeled...
Comment