NEW 2 Door golf! :D:D:D:D:D

[thestu]

Yeah that condensor is just for radio noises, not required usually.(Unless you really like listening to AM radio !)

Pete

haha loving the AM...NOT! last week one of the coil wires was burning... i have no idea why...so i disconnected the one that was shorting and ran a whole new one and ever since it was good...until you leave your car with someone else

the guy said "yeh it was running while i held the key on but as soon as i stopped cranking it wouldn't run." I almost knocked him out.

[Peter Jones]

Sounds like a fuse would be a good idea!

Pete

[thestu]

Sounds like a fuse would be a good idea!

Pete

well i plugged it in through the standard loom that plugs into the fuse box so surely it would have a fuse? if not i guess i will have to find a circuit that does.

[Water Boy]

You need a resistor as the coil only needs 8 volts.

[thestu]

You need a resistor as the coil only needs 8 volts.

ok...what ohmage bro?

[Volvo Driver]

Sounds like you had a way too picky RWC inspector, mine didn't say anything about ride height or exhaust noise...

[Jarred]

Sounds like you had a way too picky RWC inspector, mine didn't say anything about ride height or exhaust noise...

have you heard his exhaust?? hahahah

cop bait

[GoLfMan]

Sounds like you had a way too picky RWC inspector, mine didn't say anything about ride height or exhaust noise...

u obviously havent seen how low it is either.... your Volvo isnt low, or loud

the place i went to didnt say anything either after i waved cash in their face and my mk1 is belly ached and sets off car alarms.

[thestu]

Sounds like you had a way too picky RWC inspector, mine didn't say anything about ride height or exhaust noise...

oh man you have no idea...LOL the exhaust was a straight through 2.5" with a 3 inch" resonator. and once it was running they said well we can't even talk over it so its definitely over the limit no point testing it.

it is too low because my front duck bill got totalled and the lower stress bar got scrapped on a FLAT driveway...

trust me its too low and loud. no for me but for a RWC anyway

[Preen59]

oh man you have no idea...LOL the exhaust was a straight through 2.5" with a 3 inch" resonator. and once it was running they said well we can't even talk over it so its definitely over the limit no point testing it.

it is too low because my front duck bill got totalled and the lower stress bar got scrapped on a FLAT driveway...

trust me its too low and loud. no for me but for a RWC anyway

Jack it up with bump stops...

Get a plate, whack a couple of 13mm holes in it and stick it between your flange for your extractors and exhaust. It'll ride rough as hell and go like crap, but it'll be high and quiet.

Easy.

[thestu]

Jack it up with bump stops...

Get a plate, whack a couple of 13mm holes in it and stick it between your flange for your extractors and exhaust. It'll ride rough as hell and go like crap, but it'll be high and quiet.

Easy.

LOL

or i could just wind up the coilovers and pay for a new exhaust...DONE!

[Preen59]

LOL

or i could just wind up the coilovers and pay for a new exhaust...DONE!

Or you could wind up the coilovers and get a new exhau... Oh, yeah good idea..

[Oneofthegreats]

Jack it up with bump stops...

Get a plate, whack a couple of 13mm holes in it and stick it between your flange for your extractors and exhaust. It'll ride rough as hell and go like crap, but it'll be high and quiet.

Easy.

Just don't get caught with it!

You'll have to sell your body & then some to pay the EPA fine.

[Preen59]

Just don't get caught with it!

You'll have to sell your body & then some to pay the EPA fine.

Past experience? haha.

[Oneofthegreats]

Past experience? haha.

Why do you think I can't afford to finish all my project?

I sold myself very cheaply & the demand out sold the supply!!! ha ha