If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
finished off all the welding. and already laying bog and the smoothing continues!
pics speak for them selves.
oh, and don't mind the pop corn!
straight... nice...
This is all the trouble I went through with the roof. all the bare metal spots are/were rust spots (from bird poo etc} not high spots... infact, now, they're low spots! nothing a bit of feathering and highfill wont fix.
yea, I'll have to get you over to have a look at that rear left qtr. it's getting there but still needs work. another set of eyes defiantly wouldn't hurt!
So it turns out that I go back to Uni first week of March!
I was hoping to have this done by then - alas not to be. At this rate I'll be lucky to have some primer down by end of next week.
Looks like I better get a moooove on. Bugger.
EDIT: Good news is, I am making progress. 3 out of 10 of the main body work areas [filler] are done, and all the others are close. Rest of the body & hanging panels are pretty much at final prep stage, then they'll be good to prime.
Comment