If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
Measure up the inside of your rear beam and find a thick front sway bar off a car at the wreckers that will fit inside the beam. Get the brackets that came with it and weld them to your beam. Much cheaper way of doing it.
Front sway bar doesn't make much difference on a front wheel drive car but can be handy to fine-tune the handling.
Comment