Announcement
Collapse
No announcement yet.
Search Result
Collapse
9 results in 0.0078 seconds.
Keywords
Members
Tags
-
-
Lynx M150 Manifold / Weber DCOE Jetting?
Hi All,
I'm hoping someone has information on the best DCOE and jetting to use with an M150 manifold?
I'm running a 1600 Mk1 motor, mild cam, extractors and a 2 1/4 inch exhaust.
I've got a DCOE 40, I think with 28 chokes.
Previously (22 years ago) I ran a 45DCOE, but I don't...
-
Lynx M150 Manifold / Weber DCOE Jetting?
Hi All,
I'm hoping someone has information on the best DCOE and jetting to use with an M150 manifold?
I'm running a 1600 Mk1 motor, mild cam, extractors and a 2 1/4 inch exhaust.
I've got a DCOE 40, I think with 28 chokes.
Previously (22 years ago) I ran a 45DCOE, but I don't...
-
Dellortro/Weber Tuning
Hey all, does anyone know a great place in Sydney that does side-draft tuning and knows how to tune Dellorto DHLA 40G's?
These are the pair of 40 G's I have picked up. Plan is to put them on my 1.6L and 276 cam. Anyone who has done this conversion what was your jet,air,emulsion setup?...
-
1.8L 8v JH engine + mk1/8v spares
Hey guys,
I'm doing a swap in my mk1 and will have the old JH up for grabs. It's burning oil so could be as simple as stem seals, or as complex as piston rings. Sadly I won't have room to hold it and figure out what the problem was my self, so someone else is welcome to take it off my hands...
-
32/36 Weber jetting 1.8 8v
Hey everyone,
Just hooked up my new (old) 1.8 8v ADZ engine in my mk1. Bought Elton's old 32/36 Weber and bolted that up to the single point injection manifold (stock manifold on the ADZ mk3 1.using some adapter plates I machined up.
Roared to life. Timing, dizzy and earthing...
-
help needed: weber 32/36 tuning
Hey guys,
So I had my weber tuned at a shop about 2 months ago. It runs great, except when going from 1/4 to full throttle (cruising to 'punch it marty!'). It bottoms out for about half a second and then goes H.A.M (hard as motherf@#$er). The tuner said that this couldn't be helped as there...
-
WTB Weber carby and manifold for mk1 golf
Wanting to buy a weber carby with a manifold that will fit a mk1
-
FS - Weber 32/36 DGV with Passat TS manifold to suit 1.8 8v mk1/mk2/mk3?
FS - Weber 32/36 DGV with Passat TS manifold, tuned and jetted for a 1.8 8v
I'm after $250 negotiable for the whole set up need to move it ASAP!!
Fully rebuilt carb, perfect upgrade for any mk1/mk2 or even mk3 if you want to run carbs
2025 - Below Forum
Collapse
Test Slow
Collapse
