T5 Tyres 17" what is available in OZ

[Sunny43.5]

A bit hard to tell for certain from the pics but I would be aiming at alighnment as the first thing the LH side of the above picture of the tyre looks suspiciously like its scrubbing a sure indicator of alighnment problem . Too low a tyre pressure will result in the outer of both sides showing wear and vise versa if too hard . Had same look on my work van tyres until the tyre people waved their wand over it .

[Foxpuppet]

T5 Tyres 17" what is available in OZ

Question on pressure vs wear.
On my placard it shows:
light load front 44psi rear 38psi
Heavy load front 49psi rear 49psi
I've done just under 15k on my maxxis MA P1 and I've been running pretty spot for that time on 44psi front and rear. My van is never fully loaded probably less than 300kg in there including me.

I have noticed that my rear tyres are wearing faster than the front.
Checking the wear indicators:
Front drivers side - outside 3mm inside 4mm
Front passenger - outside 3mm inside 3mm
Rear drivers side - outside 1.5mm inside 3mm
Rear passenger side - outside 0.5mm inside 1.5mm

Would this be down to pressure, alignment, driving style or a combination of all?

Pressure too low/high?

Just finding it unusual to lose rubber from rear tyres faster than front on a FWD.


rear drivers side

front drivers side



Sent from my iPhone using Tapatalk 2

[Sunny43.5]

Yes you are right I had forgot the P plate bit but some kids can get an exemption , and I was also guilty of owning a VF Valiant wagon with the 318 Fireball V8 auto at around 19 and I also used to light up tyres at any given opportunity , but used to keep good quality Toyo's on the wagon [was also constantly buying new ones ] . Unlike today the old cars could take a beating especially the auto's of the era .

[brad]

Not sure about SA but in NSW & VIC p-Platers aren't allowed V8s.

There will always be cheap, powerful cars available. I had a 5.9L Chrysler when I was 22. A new set of rear tyres would last me a month. Luckily I worked at a tyre shop & used to get free 2nd hand tyres.

[Sunny43.5]

Yes I know that the speed rating is for the maximum of any car etc ,I will admit my comment was thought out as only just north of SA they are contemplating going back to higher speeds . Yes agree that not every one drives at the speed limit posted so they have to make allowances for those who will push the boundaries . Reminds me of every time HSV release a new more powerful model in its ridiculous need for speed to entice customers , what they fail to take responsibility for is that these deadly missiles on wheels will end up in second hand car yards some years from now as $10.000 ****ters and some 17 year old buys them and cannot afford the $800 per tyre they are supposed to use and the car is still capable of warp speed and then the inevitable will happen .

[brad]

So South Australia regulate the rating to 180kmh question what is the speed limit in SA ??? I just checked maximum on some roads 110 kmh don't make much sense does it .

Not everyone needs to or has to drive at the speed limit. eg: emergency service vehicles.

It's a bit like designing civil infrastructure. Sure a bridge might have a footprint big enough for 500 fully laden semi-trailers but you design it for 5000.

The hubs on my MTB are rated for an 80kg rider but I weigh 90kg & they are still holding up because of the margin for error designed into them.

[Diesel_vert]

However the law may be different

It is.

Every state in Australia only requires that any tyre fitted to a passenger vehicle be capable of 180 km/h or higher.

So, the tyre should always match the max. speed the vehicle is capable of.

I agree with that, but I'm only stating what the law is - I didn't say it was good law.

[Transporter]

Well, the principle or not, you won't buy a new car capable of the max. speed of 200km/h or higher, with the tyres that are rated to 180km/h only.

Also, the speed rating may be less when the tyre that is rated at 180km/h is 5years old, only 1.5mm of the tread ramaining and was punctured and repared. I also beleive that the tyre that was repaired has not the same guaranteed speed rating.

However the law may be different, my reply to Sunny43.5 was to his responce to 180km/h when the speed limit in the state is only 110km/h and to remind him the above.

If, and only If, I'd need to rush my family member to hospital and the road conditions allow, I wouldn't even think about the speed limit on the road or getting the ticket or losing my licence. Would you?

So, the tyre should always much the max. speed the vehicle is capable of.

(for the smart ones, we have the ambulance cover, that's why I used "if" ).

[Diesel_vert]

A tyre's speed index not only indicates its maximum operating speed (as defined under specific and ideal conditions), but it can also be reflective of its construction.

I think a safe vehicle is a vehicle where every component is able to withstand whatever the vehicle is capable of, irrespective of whether these capabilities are limited by the road rules.

I also think a vehicle should not behave in a manner or be driven in a condition that would present itself as a hazard to other vehicles on the road.

So South Australia regulate the rating to 180kmh question what is the speed limit in SA ??? I just checked maximum on some roads 110 kmh don't make much sense does it .

Vehicle manufacturers, tyre manufacturers and the road authorities highly recommend that replacement tyres have the same load and speed index of the original tyres.

I would also agree with this principle:

The tyre rating has to match the max. speed of the vehicle.

But as it is, most states only require that any tyre fitted to a passenger vehicle be capable of 180 km/h or higher.

[Transporter]

So South Australia regulate the rating to 180kmh question what is the speed limit in SA ??? I just checked maximum on some roads 110 kmh don't make much sense does it .

The tyre rating has to match the max. speed of the vehicle.

[Sunny43.5]

So South Australia regulate the rating to 180kmh question what is the speed limit in SA ??? I just checked maximum on some roads 110 kmh don't make much sense does it .

[A team]

Has anyone had Kumho KU27's.
Apparently they are long lasting but what are they like for noise, grip, etc.
What else is out there for around that $200 mark thats good value?
Any help would be appreciated.

[greymad]

The authorities in most jurisdictions will generally advise you to adhere to the original specifications as defined by the manufacturer. In most instances, deferring to the manufacturer on what should and shouldn't be done is usually the most safest and reliable option.

However, the regulations in South Australia requires that whatever tyre is fitted to a passenger vehicle must have a rated operational speed of at least 180 km/h (a speed index of S).

As far as the law is concerned, fitting 235/55 R17 103V XL (240 km/h) tyres on your particular Transporter is more than acceptable.

Thanks... I spoke with (another) tyre guy today and he is reading from the same page as you re speed ratings: different when talking about load ratings, however - and I'm reasonably comfortable with that, although the "safety margin" applied seems to be super generous/conservative in most cases.

[Diesel_vert]

The authorities in most jurisdictions will generally advise you to adhere to the original specifications as defined by the manufacturer. In most instances, deferring to the manufacturer on what should and shouldn't be done is usually the most safest and reliable option.

However, the regulations in South Australia requires that whatever tyre is fitted to a passenger vehicle must have a rated operational speed of at least 180 km/h (a speed index of S).

As far as the law is concerned, fitting 235/55 R17 103V XL (240 km/h) tyres on your particular Transporter is more than acceptable.

[greymad]

"The automaker works out the worst-case scenario and chooses a tire with a speed rating that gives even the least-informed driver a safety net. "
Dummies rule, and the rest of us pay the price, eh?
I put the same question to a tyre dealer today and his version was that the guage of the fibres (he used the word "denier" - I associate that as a term used to describe Nylon stockings...not mine) was different. So if I always have the tyre pressures up to spec. and I never travel over 110k/hr one would think it possible to go down the speed rated scale. But of course we always have the Big Brother Brigade to spoil life for us, don't we.