I ended upgrading the Howling Moon Alu awning to a Fiamma F45Ti with the matching privacy room.
Awning was mounted to the Thule commercial aero bars using fabricated steel brackets. I fabricated four brackets using mild steel flat bar. Each bracket fixed to the back of the Fiamma awning case. There are channels cast in the awning case extrusion for this purpose. The other end of the brackets were secured to the Thule bars using double length Tee nuts.
The top of the awning case ended up just below the top of the bars. So no issues loading full width timber sheets...
Unfortunately no detailed pictures as I sold the van with the awning dismounted. I was in the process of getting the brackets powder coated when I changed vehicles...
Attached is a photo from the current (happy) owner. You can just see the awning case relative to the roof bars...
Awning was mounted to the Thule commercial aero bars using fabricated steel brackets. I fabricated four brackets using mild steel flat bar. Each bracket fixed to the back of the Fiamma awning case. There are channels cast in the awning case extrusion for this purpose. The other end of the brackets were secured to the Thule bars using double length Tee nuts.
The top of the awning case ended up just below the top of the bars. So no issues loading full width timber sheets...
Unfortunately no detailed pictures as I sold the van with the awning dismounted. I was in the process of getting the brackets powder coated when I changed vehicles...

Attached is a photo from the current (happy) owner. You can just see the awning case relative to the roof bars...
Comment