EOI for 9N(3) Rear UNIbrace XB

[vert1]

I'm going to be making these for 9N Polo's, CNC cut from 8mm plate with a 25mm square reinforcing bar along the top.
How many of you would be interested?
They will be well cheaper than whats currently available and being from NZ shipping will also be cheaper.
Here's one I made for my MK4 Jetta coupe, R logo is inlayed with a red or blue acrylic logo.

[noone]

looks interesting, I'm interested but want an easily removable solution. any idea on a cost?

[vert1]

It will install with 4 bolts, takes about 5min to remove it.
Pricing came in at $395 NZ, would be good to do a batch of 5 units for Polo's.
My wife drives an 06 3 door so getting the measurements is easy enough.

[vwthunder]

It will install with 4 bolts, takes about 5min to remove it.
Pricing came in at $395 NZ, would be good to do a batch of 5 units for Polo's.
My wife drives an 06 3 door so getting the measurements is easy enough.

Im sure if you make up 5 you will sell them

[DeanB]

I'm interested in one. Dumb question, but what is it bolting to and will I need to hack into carpets, etc to fit it ?

[vert1]

You need to drill 4 holes and install riv nuts (inc with brace) and that way it can be installed and removed with 4 bolts (also supplied)
The carpet covers the area where you drill the holes and carpet in this area will need to have a 8mm hole for the bolt to pass through, if done correctly it will look factory when the seats are down and brace removed.
I don't mind making them if I can get some confirmed numbers, can even change the logo to GTI instead of R.....