If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
The Polo is no longer my daily, so looking to make it into a full time hillclimb car. Keen to remove the passenger seat. What do I need to know/do, especially regarding airbags?
my fit up starts from about here I think. Basically when you remove the seat you have to unplug the plugs. The two wire plug is only on the drivers side and is the seat belt alarm. The three wire unplugs and then you can cut off the receiver on the seat side leaving some wire length, solder onto the correct wires the resister value you need to bridge out the airbag, and then plug that plug back in and tie the loom out of the way. The correct vale is in the thread and has worked for me - think I initially got an interwebs bum steer and then Hayden set me straight. Still road reg or trailer car?
Sweet, yeah I eventually found it in your thread. Still road registered for a while, but will be caged eventually so will go on trailer. One of the reasons I got the Amarok, good tow car [emoji16]
Tweet
Comment