Originally posted by whiskywallah
View Post
Thanks!
Yes RCD510 do accept same VCDS commands as RNS510. So you can enable line out signals using VCDS. But I am not sure it is possible to enable only front leaving rear at speaker level.
To get audio out from RCD510 and put back amplified signals to speakers you need to have that interface cable I posted in the link. What it basically does is separate audio wires going to speakers from RCD510 in the middle and give you two connectors as audio out and speaker in.
audio out connector goes to your amp and amplified signals send back to other connector for speakers. These two connectors are 8 pin connectors include two pins for each audio channel (four channels , 2 front and 2 rear) . If you want RCA connectors you can solder 8 RCA sockets to replace these two big 8 pin connectors.
There is not much control in sound quality or eq functions with RCD/RNS 510 only Bass , Treble, and Mid control. I am using Audison Bit ten equalizer wich is cable of 32 band dsp equalization for each channel with other advance sound manipulations like time delays and phase control etc. I recommend it if you are in to sound quality seriously.

Yeah there is no base out from RCD510. Your amp will have to derive this from other signals or a DSP like bit ten can do this for you.
Also have a look at this thread it will give you a idea of the interface cable I described before.

Comment