R-Line High Beam

[SNOBUM]

Thanks for everyone's help - I have got High Beam Assist to work a treat!

I followed NZ_GolfR instructions, however I found that I did not need to code Byte 2 on my BCM (09) module - just left it as found - just adjusted adaptations as per instructions and coded A5 Byte 21.

Have not been able to find the speed adaptation as yet, so it activates at about 65kmh at the moment. Does not appear to be in module A5, but probably in 09.

[artful]

Thanks for everyone's help - I have got High Beam Assist to work a treat!

I followed NZ_GolfR instructions, however I found that I did not need to code Byte 2 on my BCM (09) module - just left it as found - just adjusted adaptations as per instructions and coded A5 Byte 21.

Have not been able to find the speed adaptation as yet, so it activates at about 65kmh at the moment. Does not appear to be in module A5, but probably in 09.

I have done the module 09 adaption, but i couldn't find any module A5 in my VCDS.
So i tested to skip module A5 and it does show light assist in my infotainment and at AID, but one activate is say Failed Light assist.

[NZ_GolfR]

I have done the module 09 adaption, but i couldn't find any module A5 in my VCDS.
So i tested to skip module A5 and it does show light assist in my infotainment and at AID, but one activate is say Failed Light assist.

Module A5 is "Front Sensor Driver Assistance" which controls the camera in the front it uses to dip the headlights as well as Adaptive Cruise Control. Depending on the model you have you might not have this camera so therefore won't be able to code this option.


Sent from my iPhone using Tapatalk

[artful]

Module A5 is "Front Sensor Driver Assistance" which controls the camera in the front it uses to dip the headlights as well as Adaptive Cruise Control. Depending on the model you have you might not have this camera so therefore won't be able to code this option.


Sent from my iPhone using Tapatalk

Thanks NZ_GolfR for your prompt reply, Oh dang my model doesn't come with front camera.

[Adz11]

Artful what model do you have.

[artful]

Artful what model do you have.

I'm from Malaysia, which the model doesn't have full DAP system, only partial.
It only come with

• Park Assist, parking bay and parallel parking assistance
• Active Info Display with customisable menus
• LED headlights with dynamic cornering lights

[wingzee]

So I think I have managed to have some success here with activating this wit the R-Line LED lights. Here is what I have done (using OBDeleven):

Make sure Lights are switched off
Control Unit: Central Electronics (Hex09)
Adaption - Fernlicht_assistent - Menuesteuerung Fernlichtassistent: Change to Present
Adaption - Fernlicht_assistent - Erweiterte_Frenlichtsteuerung: Change to AFS, FLA, Fernlicht ueber AFS (mine was originally set to: AFS, Fernlicht ueber AFS) - This was the important change that wasn't documented anywhere else and seems to stop the rest of the coding from working.
Coding - Long Coding - Byte 2: Change to Hex3 (Bit 0=1, Bit 1=1)
Control Unit: Front Sensors Driver Assistance System (HexA5)
Coding - AFS_coding_Light_assist: Change to High_Beam_Assist (Long coding Byte 21 - Hex 20 (Bit 5=1))

Once I had done this I now have Light Assist showing in the Car Settings Menu under Light Settings:

[ATTACH=CONFIG]29242[/ATTACH]

And when I flick the lights stalk forward I get the Light with A in it showing on the AID:

[ATTACH=CONFIG]29243[/ATTACH]

Now I just need to test to see how well it works....

Thanks for this mate! Have you tested and confirm that it works? Does it only gets triggered when above a certain speed? Is it possible to adjust that?

[nibose]

Hi,

Is there anyway to enable High Beam Assist for Golf with halogen headlights? My car has all the other sensors/camera etc.

Cheers