Front And Rear 8 Sensor 8K PDC OPS - Control Module not coded

[Antpngl92]

Hi all,

I had an 8 sensor PDC OPS retrofitted on Golf mk6 2.0TDI 140hp several weeks ago in a local garage.

Unfortunatelly, the module was faulty (not OEM) and the guy who mounted the OPS advised me to buy a new one.
I purchased one from eBay (OEM) with part number 5K0919475E.

Now, I cannot visit the local garage because they messed up other parts of the car (this is another story) and after fitting the new module I get a long beep and a flashing rear sensors button. I purchased a VCDS to check what is going on and got this code error:

Address 10: Park/Steer Assist (J446)  Labels:. 3C8-919-475.clb 
   Part No SW: 5K0 919 475 E HW: 5K0 919 475 E 
   Component: PARKHILFE 8K H01 0012 
   Revision: -------- Serial number: 12532131601725 
   Coding: 000000 
   Shop #: WSC 00000 000 00000 
   VCID: 387CBFD4B3621447CF-806C

1 Fault Found:
01042 - Control Module; Not Coded 
    000 - - 
    Freeze Frame: 
        Fault Status: 01100000 
        Fault Priority: 3 
        Fault Frequency: 1 
        Reset counter: 220 
        Mileage: 188557 km 
        Time Indication: 0 
        Date: 2016.11.28 
        Time: 21:30:59 

    Freeze Frame: Temperature: 30.0°C

I gues the error code is pretty self explanatory - the new module needs to be coded.
I will very much appreciate if anyone can help with the coding part or at least share some resources that would
help me code the module.

Cheers