If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
GSL were unable to source a dual piece rotor and there were no single piece rotors in the country. DBA are working on a set, but they're not yet available. I ended up grabbing a set of drilled rotors from ECS.
I'm still following the bed-in process for the pads. Hopefully they'll stop as good as they look because they're horn.
Comment