Mk4 R32 Perforated Grills

[Fizz]

Hey Guys does the Ozzy R32 have both the left and right Lower Front Grills perforated? As Ours only has one side perforated and my mate with the R wants to have them both. If the Ozzy R does come with the perforated Grills anyone has a part number?

Thanks

[quozl]

Hey Guys does the Ozzy R32 have both the left and right Lower Front Grills perforated? As Ours only has one side perforated and my mate with the R wants to have them both. If the Ozzy R does come with the perforated Grills anyone has a part number?

Thanks

No it doesn't it's a do it yourself mod, well for MKIV R anyway.

Take the grill out using a small flat blade screw driver to carefully lift the bottom tabs, get a decent quality narrow box cutter or scalpel (hobby shops have these), some extra blades and a hair dryer.

Gently heat the grill for a few seconds with it facing up on a solid surface and push the blade through following each edge of the diamond. Once all of them are out fold up a piece of wet n dry and gently smooth out the dags. Make sure you leave one row solid around the outside edge as per the one already open on the other side of the car to keep it rigid enough so it doesn't pop out. Takes about 30 minutes to remove all of them and sand the dags off.

Cheers Al

[balkanac]

i have a CAI air filter behind it, i dont think i'll be opening it

[Fizz]

Cool, we'll give it a go this coming weekend

Thanks Al

[quozl]

i have a CAI air filter behind it, i dont think i'll be opening it

That was the nice thing about using the BMC CDA intake the hose hung down there but there was no issue about the filter getting wet or it sucking in water.

[balkanac]

thats true quozl, but when i was deciding which CAI to get, BMC one was way too expensive, so i went with Neuspeed and i love it!

[Treza360]

Hmmm.... Thoughts for future modification plan.
I take it the BMC Air Filter is the best CAI option?
How then does the Carbonio compare to the Neuspeed?
Al, how come with the BMC intake you don't have to worry about water entering? Looking at the BMC site they say not to put the intake down too low.
Cheers
Trent

[quozl]

Hmmm.... Thoughts for future modification plan.
I take it the BMC Air Filter is the best CAI option?
How then does the Carbonio compare to the Neuspeed?
Al, how come with the BMC intake you don't have to worry about water entering? Looking at the BMC site they say not to put the intake down too low.
Cheers
Trent

Any intake will suck water if you drive through deep enough water. As you can see by the pic above the intake hose was only slightly turned down where a lot of the pod type filters sit right down behind the horn making it easier for water to be ingested.

When I was running the BMC I never had an issue in any of the rallies I competed iat with ingesting water and some of them were very wet. With the updated CAMS Tarmac rules I am no longer allowed to run an intake it has to be stock so we run the DSG R32 MKIV airbox and intake from the Euro R as it is a larger intake pipe than the Australian version. Testing with VAGCOM showed it was pulling the same gram per sec air as the BMC.

As for which intake is better I'm not touching that with a 10 foot pole, when i installed the BMC in early 2004 I went with it as it was the only option available at that time.

Just after this picture was taken at Wheels on Wide Bay I went through the main part of that puddle and water was everywhere over the bonnet and screen but had no ingestion issues, your only going to have a problem with any intake if the road is flooded and your trying to ford your way through, in saying that though if the pod filter is down there it's going to get wet and stay wet allowing some water to be ingested where as with the hose in the position I had it there's nothing there to trap the water.

Cheers Al

[Treza360]

<snip>

Thanks Al. Lots of food for thought. A CAI will be a few months away anyway. Tyres are first on the list.

[balkanac]

If you are so worried about sucking up water, get a bypass filter and nmount it inder the bonnet and you'll be fine

[fuzion]

http://cgi.ebay.com/ebaymotors/NEW-AEM-COLD-AIR-BYPASS-BY-PASS-VALVE-BPV-3-20-403S_W0QQcmdZViewItemQQcategoryZ33659QQihZ001QQitemZ110179216842QQtcZphoto

try that

[ranton-inc]

The Holey Grille

young fizzy boy asked this question on my behalf before i signed up here.. but end result was good

So as it was posted on eurosport.org.nz...

So i was bored this Arvo, No Drinking buddies in town so i thought i would just start trying to make the R32 look a bit better for as cheap as possible.. ;D

it wasnt much but hey it was better than nothing!

It goes a little something like this...
+

equals
&

times that by 3 Hours and it equals



Which proves that...


is Greater than...
&



I too have a CAI.. but this i beleive has greatly benefited it its now got cold air blown straight on to it which is kinda a good thing init?

[Fizz]

Good 2 see you made your way on here Anton

[balkanac]

Should be a very good thing, but i'm still not gonna do it to my car. The POD filter is just behind it, and i don't wanna think about it every time there is some water on the road (not that it happens often in Perth ).

[ranton-inc]

Should be a very good thing, but i'm still not gonna do it to my car. The POD filter is just behind it, and i don't wanna think about it every time there is some water on the road (not that it happens often in Perth ).

So is mine?

water blowing on to it isnt going to do jack

i knows as it was pissing down hard for the last 4 days

is when you completely submerge the pod in a puddle thats when your going to have a problem!