Tweet
Looking to replace some bushes just to refresh the front end a bit, just wondering the frotn sway bar stock size on a 2001 GTI if anyone knows?
Cheers.
Cheers.
-
2001 MkIV GTIRevo Stg 1 - K&N Intake - Forge DV -
Not sure if it's the same across all models, but mine is (or was
) 21mm on a mk4 2.0.
-
I have a feeling its the 21mm, but I dont even have calipers to get under a check
2001 MkIV GTIRevo Stg 1 - K&N Intake - Forge DVComment
-
This might help: (has front and rear)
VWVortex.com - MKIV rear swaybar list
Are you thinking of upgrading your front?Comment
-
I just got mine replaced and I'm pretty sure it was around 21/22mm (cant quite remember now) Mine is a 2001 GTIComment
-
Blocking the lows. Mines getting the chop'02 GTI (clicky) - REFLEX SILVER - VIEZU race tune. VAR design 2.5inch stainless steel dump pipe with 100cell cat into 2.5" billyboat stainless cat back, Forge TIP, N75, Audi DV, ghetto CAI, FK-AK s coilovers, tunerdone LEDs, Clarion CZ301E sound stage.
Comment
-
I just want to replace the D bushes on it. Could someone please measure theirs on the GTI by any chance?2001 MkIV GTIRevo Stg 1 - K&N Intake - Forge DVComment
-
I did one that had the bed spring creak so best you check the OD and then the OD where the bush sits, no doubt after you clean it itll be 1mm under. From memory the sway was 22mm and i fitted 21mm poly bushes lubed and it was whisper quiete.
Dont just rely in the sway measurement, i would recommend measure the wear area when super cleaned
Cheers
JmacAlba European
Service, Diagnostics and repairs. Mobile Diag available on request
Audi/VW/Porsche Factory trained tech 25+ yrs exp
For people who value experience call 0423965341Comment
Comment