If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
Ive seen washers done plenty of times and they are all good.
but in my mind, with the washers the stub axel wont be bearing correctly and evenly.
because a shim (metal or plastic) sits across both surfaces it should be ok, plastic might just wear down over time?
Tweet
Comment