VR6 Compression Testing

[Hakan]

Good to be back after a little getaway from the Golf
Im only 2 days from getting my license back so I decided to do a Major service on My golf vr6 .
Today I have pulled out my spark plugs and they were rusted on top but superclean where it fires up .}
Also I have done a Cold engine Compression test on each Cylinder @ 3 seconds each and my Reading were Off The Gauge
Gauge Meter 0-200 LB / 0-14 Kg
Readings were all the same :
360 degrees all around the gauge untill stopper Needle which = roughly 300 LB
I dont think a MK4 Head gasket would Cause this .
engine is very responsive not that im complaining but it just annoyed when I couldnt get a reading .

[Smeeeb]

VR6 Compression Testing

Maybe you just have a God engine.

[HaydEn]

VR6 Compression Testing

Vr6's 'new' limit is 180-190psi.

[Smeeeb]

VR6 Compression Testing

Vr6's 'new' limit is 180-190psi.

^

Is you engine running any other modifications. Maybe your compression test went weird.

[Hakan]

only a MK4 vr6 headgasket and a rebuilt head and shaved down but that would not cause compression to go higher because the chamber is in the block
i tried the compression tester on another engine and it was fine .
my vr6 is almost 300 psi
the engine is dead cold which would mean that the rings would not have expanded .
im just getting Hi compression the is the gauge reading

and Dyno Sheet

[KKK VR6]

3 seconds
Umm try it again but give it Only 2 or 3 turns.

The important bit is that they all give the same reading !

[Hakan]

There all the same the needle jumps to 170on 1st then 230ish 2nd an keeps going untill it hits the needle stopper

[HaydEn]

VR6 Compression Testing

Get down to supercheap buy a other one, use it, then see what happens. Then take it back and say it doesn't fit,

[Hakan]

Yeah thats what im thinking of doing thanks

[Hakan]

Anyone going to " I love Vw " in March ? Hopefully I Am with the Golf slapped and the Kerschers On Cant wait to meet You guys

Also Found my Cat was blocked thinking of a mandrel bent bolt on 2.5" exhaust before ILVW .

[Smeeeb]

VR6 Compression Testing

Anyone going to " I love Vw " in March ? Hopefully I Am with the Golf slapped and the Kerschers On Cant wait to meet You guys

Also Found my Cat was blocked thinking of a mandrel bent bolt on 2.5" exhaust before ILVW .

Link now.

[Hakan]

http://www.vwwatercooled.com/forums/f21/ilv-summersun2013-march-10-2013-a-80526.html

[Smeeeb]

http://www.vwwatercooled.com/forums/...3-a-80526.html

How have i not seen this.