If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
I just installed the replacement fog lights and turn signal that I bought from ebay, look really nice and fit in no probs, however, the indicators now flashing really quickly....... anyone know why? And how to fix, as sometimes the right one is normal then speeds up. random!
Is it only one side ? It should be the contact of the opposite bulb.. I had exact same problem.. randomly flashing.. try taking the bulb out, wiggle it around a bit.
yeah that is so that you know there is a problem in the circut, do the ind work ? they normally flash fast when a blub goes out so you know its out.
have a look to see if all the blubs are working then check the earths for each one.
cheers brenton
It can also mean that you have not made contact properly with the indicator! When I was driving my car to the panel beaters I had all that stuff off and got the fast flashing cause nothing was in there!
I had this problem too, except it was when I indicate. When I put the hazards on, they flashed at normal speed. This was happening cos I did not have the front indicators wired in; the wires were just dangling about at the front. Once I wired them back in again, they worked fine.
Comment