If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
Its a Vento one mate. I have half of one at the shop.
sigpic Camden GTI Performance. VW / AUDI Specialists
All Mechanical Work, Log book Servicing, New and used Parts and Imports
19-20/6 Badgally Road, Campbelltown, 2560 02 4627 3072 or 0423 051737www.camdengti.com
Will this vento, lip fit onto my mrkIII GL's bumper?
I've tried fitting the vento one to my golf but apparently the vento front bar is wider than our golfs It didn't want to go no matter how much a persevered
I've tried fitting the vento one to my golf but apparently the vento front bar is wider than our golfs It didn't want to go no matter how much a persevered
Cheers matey. I'll just go a duckbill for my GL. Coming to you soon(ish ) Mr Loon
Cut down duckbill can look alright if you do it properly and neatly. Done one on mine, doesnt look too and and similar to the NA lips! Had to do it because even my duckill was getting ripped off all the time and I'm not a huge fan of the look of them normally. My VR lip is even worse with the bumps and pot holes so stays off until shows or cruises!
sigpic
| MY15.5 Mk3 Octavia vRS TSI | DSG | Black Pack | H&R Springs | 18" BBS RSII |
Comment