If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
I wouldn't have the foggiest idea! Appears no one has either!
Best to go to your local bearing supplier as they might be able to cross reference. Bit hard!!
Ok, I know you guys have said that you dont use the AMV 188 001 82 paste for the oil cooler to flange sealant,
but Bentley again says to use AMV 188 001 02 paste on the G60 block where there is a plate to seal off the hole for the coolant passage into the block on the cam belt side.
Comment