RNS-510 repeat last navigation instruction?

[silver32]

Does anyone know how to have the RNS-510 repeat the last navigation instruction with the new firmware? Previously you could press the "i" button on top right of unit, but now that button activates the voice control and I don't yet have a mic for voice control.

[Swallowtail]

Let me know when you find out, I was wondering the same thing!

[Maverick]

Let me know when you find out, I was wondering the same thing!

There's a spot you can press on the touchscreen. I think it's when you have split screen running you press inside the smaller screen on the left hand side.

[silver32]

I'll have a look... Would be simpler to press the "i" button though

[silver32]

Let me know when you find out, I was wondering the same thing!

Found it! press the right dial button, but I think you may have to be in either map/nav for it to repeat as pressing in media screen sets it to scan mode, but yeah thats the button.

[Swallowtail]

Found it! press the right dial button, but I think you may have to be in either map/nav for it to repeat as pressing in media screen sets it to scan mode, but yeah thats the button.

LOL... how the hell did you find that?

[silver32]

Stuck in traffic one day and was staring at the unit for a good while for no apparent reason... and it hit me, I tried every single "button" except the dial one.... Much happier with the firmware now.

[Maverick]

Touching the screen in the split screen area also repeats the last message.

[silver32]

Thanks, will remember that

[Swallowtail]

So next question, whats the voice command to repeat the last navi instruction?

[silver32]

Have you tried "Say what?" or perhaps, "Come again?"