Tweet
Has anyone had poor fitting Neuspeed KO4 specific Turbo Discharge Pipe? The issue I have experienced is the mounting holes not lining up with the ones in the block. Apparently Neuspeed are aware of this, so consequently have produced a revised pipe which will hopefully correct this issue. I will be sending mine back for an exchange
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages, select the forum that you want to visit from the selection below.
Your Supporter or Sponsor Subscriptions will expire soon.
We hope you will choose to stay with us!
This means you should apply for your renewal now to avoid
any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.