Tweet
hey guys, i have a 2008 caddy and i need someone with skills to code a highline cluster in for me. the problems is that its using IMMO4C type immobiliser and its not a simple job compared to earlier IMMO4 type. It 100% doable but the only person i have found that can do it is a fella from UK.
-
-
bump. no one at all ? -
Not a mainstream request mate, hence no takers.
If you need more than a VCDS cable, there would be maybe 2 people on here that could do it, none in Sydney
GavinComment
-
yea that guy told me that VCDS wouldnt be enough for the job. but did say that a place that tunes VAG cars should be able to do it.Comment
-
Bzzzztt wrong, I'm pretty sure I have the stuff to do it but not the time at the moment
.
Originally posted by h100vw View PostComment
-
Glad to be proved wrong mate. I was thinking of Transporter and Jimmy.Originally posted by parso_rex View PostBzzzztt wrong, I'm pretty sure I have the stuff to do it but not the time at the moment.
GavinComment
-
good to hear ! just let me know when you got some time to muck around with it and the cost, cheersOriginally posted by parso_rex View PostBzzzztt wrong, I'm pretty sure I have the stuff to do it but not the time at the moment.Comment
-
OK we had a look at this and sadly Its quite a complicated beast and the software I have can't at this stage do these. I can do earlier models and the later models (Golf R Amarok everything etc) but not these between 2007 and 2009.
You can't just physically move the eeprom across to the new dashes motherboard either either as the data is encrypted in one area
we have to be able to read the data within the Micronas MCU and have this match the encrypted data within the eeprom of the new dash
its off to the UK with this animal...................Comment
Comment