If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
I only removed 6mm from the radius at 20 degrees. After thinking about it i may go a little more. As you said you can wreck a crank taking too much off so it's better to sneak up on it.
looks pretty good, I also didn't notice before how massive that lathe is!!!
let us know how it goes once you pop it in!
Yeah its a little scary the first time you use it.. But you get used to using big equipment. It's great- cut depth of cut and feed are only limited by the tooling and how good you have a hold on the job!
Yeah i'll certainly give feedback.. Actually i should put a thread in the projects forum. I'm building a Mk1 4 door race car. Road registered ofcourse...
Yeah i'll certainly give feedback.. Actually i should put a thread in the projects forum. I'm building a Mk1 2 door race car. Road registered ofcourse...
Tweet
Comment