What have you done to your Audi today??

[Jmac]

Curious to see how MTl goes in the 02M, i usually use MT90 in them and MTl in the 5 speeders, feedback would be good on that one, whats the nag you mention???
Jmac

[h100vw]

SERVICE IN 100KM Jimmy.

Also need to look at the CV boot again mate. It has popped off, most of the grease is still in there, I think.

Gavin

[Jmac]

Use your VCDS mate instruments (17) then adaption, enter channel 02 and set it to 00 and save, done. Some of the older A4 used other channels and had to be set individually but 02 should be the go with the A3
Cheers
Jimmy

[Jmac]

My A4 has been bugging me with a glitchy boost fault pretty much since ive owned it ( going into limp so no leaks before we all jump) but more so after upgrading the software. Finished early today so at last had some time to check her out. removed the ECU which has been replaced ive noticed so had a smile there. Anyway keep getting the Lambda implausible signal fault pre cat so its the important one and is for sure messing with my mixtures to the point i thought i was going to p ut a hole in a slug this week, pinging its head off. Not good. So back to driving like miss daisy again till its fixed. Checked with diagram and found wrong 02 sensor is fitted its a start, new sensor Monday and hopefully i can put the lid on it.
Used Vagcom to do a log of a drive in closed loop and watch it all go pear shaped. Tried my Diagun palm pilot just for laughs, it picked it up too.
Update soon with result.
Put it through the hand car wash also and soon showed JASN78s efforts again with his clay bar, came up mint again. .
Getting closer to having it nailed i think
Jmac

[Pete@ECSTuning]

^^ Good luck with that o2 sensor fitment.

I just blew up my underbelly pan driving thought a couple feet of snow

Also, headlight multifunction switch, oil change, a new lamps up front. It was a good weekend.

[dubsweeper]

Got a new turbo for the a4 also got the front brake lines replaced , engine oil change , new g12 coolent , checked all diff and trans oils and also have some b6 rims on the car now

[Pete@ECSTuning]

B6 S4 wheels?

[dubsweeper]

no just stock ones !!

[Jmac]

Cant go wrong with OEM Imo
Cheers
Jmac

[16v80]

Bought some paint and took my A6 apart

Before and after pics to come.

[Jmac]

Lambda sensor pre cat fitted. seemed a whole lot better, cant be that easy, yeah it wasnt. Lambda fault gone though pleased to say , i think the real culprit is rearing its head. System lean!!!!! thought so i heard it ping a few times and logged plenty of timing pull, engine has new coils and platinum plugs as a rule. So now going to go for a drive with a fuel pressure gauge on , just to make sure, i suspect the fuel pump ( filter is new) and if that checks good then it calls for the one and only smoke test, ordered a smoke machine so quitley hoping i can diagnose my car with it
Jmac
Oh by the way she now rides on Eibachs. what a difference

[Pete@ECSTuning]

Nice wheel fitmet. Spacers? And is that a 1996?

[16v80]

Pics of my A6 before i took it apart



Then I did this



So I could do this




More to come

[16v80]

A few more

The sills





After the bumpers and sills were painted, I decided there was to much silver so off came my 19" BBS CH's and this happened

Before



Primer



Paint




Finished rims



And finally the car




Ian

[h100vw]

Oh yeah!

Gavin