Tweet
i lowered(30mm) my MK6 2.0TDI on Eibach pro kit last week, the gap/height between wheel arch & tyre of the front left/passenger side is approx 5mm higher than the front right/driver side. rear springs are fine. i did not measure the stock height before. the shop installer says difference within 10mm is fine. any one else has the same issue?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages, select the forum that you want to visit from the selection below.
. Pics of your TDI would be nice, I was an owner of a MKV TDI before my R32.
Comment